Abstract:The equibiaxial planar tension test is an important method for determining the mechanical properties of hyperplastic membranes, and it is also critical to designing an effective equibiaxial tension test rig to meet experimental accuracy requirements. However, any analysis addressing the accuracy of this test is not reported in the literature. In this paper, an equibiaxial planar tension apparatus is proposed for conducting single-corner-point tension tests on hyperelastic electroactive polymer (EAP) membranes. The experimental data were compared with those obtained from two-corner-point-fixed tension tests and fitted with nonlinear material models, and the model’s parameters were also evaluated. Finally, the widely-used finite element software ABAQUS was employed to simulate equibiaxial planar tension methods and investigate the impact of clamping mode and point number on test accuracy as well as the uniformity of overall deformation. The test results indicate that the stress-strain curves for the two tensions remain consistent across small stretch ratios. However, as the stretch ratio increases (about λ > 2.25 ) in two-corner-point-fixed tension, stress shielding may lead to a degradation of strain uniformity and result in greater stresses than single-corner-point tension. Additionally, both the three-parameter Yeoh model and the four-parameter Ogden model can provide an accurate description of the EAP membrane material. The simulation results indicate that the axial strain variation amplitudes remain below 5% within a region spanning approximately 80% of the specimen’s overall length from its center to edge and even below 1% within a region spanning 85% in the single-corner-point tension; stress inaccuracies increase with stretch ratio, while the calculated error is about 2.1% when λ = 4 in the single-corner-point tension test, which has the smallest stress error among the tests; when the number of tension points is increased, the overall deformation becomes more sufficient, and the test accuracy improves as well. The conclusions drawn from this paper will be beneficial in designing equibiaxial planar tension test rigs and analyzing their accuracy and uniformity of deformation.

Bulge Test Method for Measuring the Hyperelastic Parameters of Soft Membranes

A Vector-Form Hybrid Particle-Element Method for Modeling and Nonlinear Shell Analysis of Thin Membranes Exhibiting Wrinkling

Hydrodynamic Bulge Testing: Materials Characterization Without Measuring Deformation

IMPROVED NONLINEAR FORCE DENSITY METHOD ACCOUNTING FOR 2-DIMENSIONAL DEFORMATIONS OF MEMBRANE ELEMENT

ENERGY-MOMENTUM BASED APPROACH FOR DEPLOYMENT ANALYSIS OF SPACE MEMBRANE STRUCTURES

In Situ Elasticity and Adhesion Measurement of Biomembrane by a Video Enhanced Depth-Sensing Indentation Technique

A Systematic Method for Characterizing the Elastic Properties and Adhesion of a Thin Polymer Membrane

A Novel Technique for Mechanical Characterization of Thin Elastomeric Membrane

A Novel Technique for Characterizing Elastic Properties of Thin Biological Membrane

Nonlinear modeling and characterization of ultrasoft silicone elastomers

Novel technique for mechanical characterization of thin polymeric tissue membrane

Characterizing viscoelastic properties of thin elastomeric membrane

Characterization of the Mechanical Properties of Microscale Elastomeric Membranes

An innovative approach to characterize the elastic moduli of 2D materials from the central strain of bulged membrane

Equibiaxial Planar Tension Test Method and the Simulation Analysis for Hyperelastic EAP Membrane

Regional stretch method to measure the elastic and hyperelastic properties of soft materials

Pipette Aspiration of Hyperelastic Compliant Materials: Theoretical Analysis, Simulations and Experiments

Novel scanning electron microscope bulge test technique integrated with loading function.

Spherical Indentation Method for Determining the Constitutive Parameters of Hyperelastic Soft Materials

Micromechanics methods for evaluating the effective moduli of soft neo-Hookean composites

Finite deformation analysis of bi-modulus thermoelastic structures and its application in wrinkling prediction of membranes