Abstract:Background In China, traditional preoperative planning of unilateral breast reconstruction mainly depends on anthropometric measurement and visual assessment. Thus, the lack of objective assessment of breast volume and shape would likely result in suboptimal reconstruction outcomes. Three-dimensional surface imaging (3D-SI), which could provide objective measurement data of the breast, may be a promising solution to this problem. Methods A retrospective review of patients undergoing tissue expander (TE)/implant breast reconstruction without any mammoplasty surgery on the contralateral sides in our hospital from August 2013 to May 2018 was performed. All the patients underwent unilateral mastectomy with immediate or delayed insertion of TE, followed by an exchange of a silicone gel implant without contralateral procedures. 3D images were obtained at the time of preoperation, the routine expansion visit, and post-exchange of implant. The breast volume measured by 3D-SI served as a guide to conduct the surgery management, such as in deciding the total volume of expansion and guiding the final implant size selection. 3D-SI also provided objective data to evaluate the final outcomes of the reconstruction. Results Fifty-one patients were included in this study, in which eighteen patients underwent immediate TE insertion and thirty-three patients underwent delayed TE insertion. The ptosis degree of contralateral breasts was assessed as follows: forty-four were normal, and seven showed mild ptosis. The average expansion degree was controlled at 161.6% ± 14.1% compared to the contralateral breasts. The volume of implants exchanged had a strong linear correlation with the 3D volume of the contralateral breasts at the end of expansion ( P < 0.01). The mean time of follow-up was 9.1 ± 6.6 months. There was only one patient who experienced TE leakage with secondary infection and received TE exchange. For the immediate reconstruction group, the overall breast symmetry improved at the completion of implant exchange ( P < 0.01), with an average asymmetry of 5.3% ± 4.0% compared with 10.6% ± 6.1% initially. For the delayed reconstruction group, the reconstructed side achieved good volume symmetry to the contralateral side ( P > 0.05). There was no significant difference in breast basal width between bilateral breasts post-reconstruction ( P > 0.05). Conclusion 3D-SI serves as a valuable adjunct by providing accurate 3D volume of breasts within TE/implant breast reconstruction in Chinese patients without obvious breast ptosis, which could facilitate surgeons to achieve good reconstructive outcomes. Level of Evidence IV This journal requires that authors assign a level of evidence to each article. For a full description of these Evidence-Based Medicine ratings, please refer to the Table of Contents or the online Instructions to Authors www.springer.com/00266 .

Evaluating 3D Simulation Accuracy for Breast Augmentation Outcomes: A Volumetric and Surface Contour Analysis in Chinese Patients

Applications of three-dimensional surface imaging in the plastic and aesthetic breast surgery

Measurements and Analysis of Breast Morphology Changes after Breast Augmentation by 3D Scanning

Study on measuring breast volumetric change after augmentation mammaplasty using three dimensional scanning

3D scan and volume calculation of asymmetry breast for implant chosen

The Role Of Three-Dimensional Scanning Technique In Evaluation Of Breast Asymmetry In Breast Augmentation: A 100-Case Study

Clinical Application of Three-Dimensional Reconstruction Technique for Breast Volume Measurement in Mammaplasty

Digital evaluation of breast symmetry with 3D scanning technique

A Study of Developing 3-Dimensioned Computer Assisted Design for Breast Reconstruction and Breast Volume Measurement

Three-dimensional Scanning for Breast Plastic and Reconstructive Surgery: an Updated Review

Measuring Volumetric Change after Augmentation Mammaplasty Using a Three-Dimensional Scanning Technique: an Innovative Method

Improved accuracy of breast volume calculation from 3D surface imaging data using statistical shape models

Breast Volume Measurement with Computer Aid and Its Clinical Application

Unilateral Tissue Expander/Implant Two-Stage Breast Reconstruction with the Assistance of Three-Dimensional Surface Imaging

A comparative study of breast surface reconstruction for aesthetic outcome assessment

Medical Image-Guided Surgery Planning For Breast Reconstruction Using Deformable Modeling And Surface Flattening

Virtual Surgery Planning Of Breast Reconstruction Using Deformation Modeling And Curve Shape Approximation

A Prospective Study Of Breast Dynamic Morphological Changes After Dual-Plane Augmentation Mammaplasty With 3d Scanning Technique

Comparative analysis on three-dimensional assessment of breast invasive ductal carcinoma by conventional ultrasound and automated breast volume scanner

Three-dimensional reconstruction technique in breast volume measurement and its artificial influencing factors

A Comparative Study of Three-Dimensional Simulation in Nonsurgical Rhinoplasty with Hyaluronic Acid Fillers.