The Effect of pH and Ferulic Acid on Selected Properties of Soy Protein Isolate Films

bao huiyan,guo qianchu,ou shiyi,li aijun,yang aihua
DOI: https://doi.org/10.3321/j.issn:1002-6630.2004.09.011
2004-01-01
Abstract:This study was conducted to determine the effect of ferulic acid on selected properties of glycerol-plasticized soyprotein isolate (SPI) films. Films were plate casted from heated (80℃ for 30 min) neutral or alkaline aqueous solutions of SPI(5g/100 ml water) , glycerol (2.5g), and ferulic acid (0, 100, 200, 300mg), and dried in an oven at 50℃. Tensile strength (TS),percent of elongation at break (E) , color values ( L, a, and b) , and water vapor permeability (WVP) were examined afterconditioning film specimens at 25℃ and 52% relative humidity (RH) for 2d. The use of ferulic acid resulted in the increase inboth E and TS to different extents at different pHs. The addition of ferulic acid made it possible to prepare SPI films from neutralfilm-forming solutions: compared with control films without ferulic acid, the addition of 100~300mg ferulic acid resulted in anincrease of TS from 62.5% to 94.3%, and an increase of E from 24.2% to 54.4%. Increased darkness, redness and yellowness asevidenced by smaller L values and greater +a and +b values were noted for films with high amounts of ferulic acid. Nodistinguished positive effect of ferulic acid on the WVP of the films was found.
What problem does this paper attempt to address?