Wet-Chemical Synthesis of Surface-Passivated Halide Perovskite Microwires for Improved Optoelectronic Performance and Stability.

Qian Ye,Jin Zhang,Pengfei Guo,Haibo Fan,Dmitry Shchukin,Bingqing Wei,Hongqiang Wang
DOI: https://doi.org/10.1021/acsami.8b07428
IF: 9.5
2018-01-01
ACS Applied Materials & Interfaces
Abstract:One-dimensional (1D) halide perovskite materials with intrinsic high carrier mobility and long diffusion length hold great promises for high-performance optoelectronic devices, in which the passivation of the surface defects is of significance for further boosting its optoelectronic performance as well as its moisture stability. Herein, we demonstrate a simple room-temperature wet-chemical synthetic protocol for perovskite microwires with controlled morphologies and passivated surface states. This strategy allows for facile assembly of hydrophobic 1 H,1 H-perfluorooctylamine (PFA) molecules on the surface of the perovskite microwires owing to the coordination binding between the amino groups of PFA and Pb. Both steady and time-resolved photoluminescence measurements revealed that the passivation of PFA greatly benefit for the inhibition of the photogenerated carriers recombination. The constructed perovskite microwire-based photodetectors have shown increased detectivity of 4.99 × 10 jones and responsivity of 1.27 A/W (light power density of 1 mW/cm). Moreover, the hydrophobic fluorocarbon alkyl chains endow the perovskite microwires with higher resistance toward moisture. Such coating of a water-resisting layer resulted in greatly enhanced stability of perovskite microwires under the humidity of 55 ± 5% over 30 days. We thus believe that our work is of importance for the development of 1D halide perovskite photodetectors with highly improved performance and stability.
What problem does this paper attempt to address?