Abstract:The discarded lithium manganate (LMO) and lithium iron phosphate (LFP) electrodes are reused to obtain new lithium manganese iron phosphate (LiMnxFe1−xPO4) materials with high energy density and ionic conductivity. The LiMn0.6Fe0.4PO4 has a specific discharge capacity of 154.4 mAh g−1 at 0.2 C during the constant current discharge process. The capacity retention rate is maintained at 96.2% after 100 cycles. The research strategy of using discarded lithium manganate (LiMn2O4, LMO) and lithium iron phosphate (LiFePO4, LFP) electrode materials to obtain lithium manganese iron phosphate (LiMnxFe1−xPO4, LMFP) materials with high energy density and ionic conductivity is increasingly highlighted as powerful and effective. The study explores a new strategy to prepare high‐performance LMFP materials using high‐temperature sintering based on the successful recovery of LMO and LFP electrode wastes. X‐ray diffraction results show that the LMFP cathode materials are prepared successfully by using discarded LMO and LFP materials. LM0.4F0.6P and LM0.6F0.4P, whose manganese‐to‐iron molar ratio [MR(Mn/Fe)] 4:6 and 6:4, exhibit nano‐sized olivine spheres with lattice diagram corresponding to the (101) crystal planes. The constant current curves show that LM0.6F0.4P has a specific discharge capacity of 154.4 mAh g−1 at 0.2 C. The capacity retention rate is maintained at 96.2% after 100 cycles. The cyclic voltammetry curves show that two distinct pairs of redox potentials appeared for LM0.6F0.4P in the voltage interval located at (3.63 V/3.43 V) and (4.18 V/3.87 V). Thus, the proposed strategy predicts that the discarded LMO and LFP can be used as raw materials to prepare high‐performance LMFP cathode materials, significantly reducing energy consumption and environmental pollution.

Revealing the Degradation Mechanism of LiMn x Fe 1- x PO 4 by the Single-Particle Electrochemistry Method.

Improved Electrochemical Performance And Capacity Fading Mechanism Of Nano-Sized Limn0.9fe0.1po4 Cathode Modified By Polyacene Coating

Revealing the voltage decay of LiMn0.7Fe0.3PO4 cathodes over cycling

Mn-Rich Induced Alteration on Band Gap and Cycling Stability Properties of LiMnxFe1-xPO4 Cathode Materials.

Stabilizing the Structure of LiMn0.5Fe0.5PO4via the Formation of Concentration-Gradient Hollow Spheres with Fe-rich Surfaces.

Single‐Particle Performances and Properties of LiFePO4 Nanocrystals for Li‐Ion Batteries

Atomic Scale Insight on the Fundamental Mechanism of Mn Doped LiFePO4

Oxygen loss and surface degradation during electrochemical cycling of lithium-ion battery cathode material LiMn2O4

Electrochemical Performance and in Situ Phase Transition Analysis of Iron-Doped Lithium Manganese Phosphate

Increase and discretization of the energy barrier for individual LiNixCoyMnyO2 (x+2y=1) particles with the growth of a Li2CO3 surface film

A Novel Strategy for Preparing Nano‐Sized and High‐Performance LiMnxFe1−xPO4 Cathode Materials from Discarded LiMn2O4 and LiFePO4 Electrode

Suppressing the Structure Deterioration of Ni-Rich LiNi0.8Co0.1Mn0.1O2 Through Atom-Scale Interfacial Integration of Self-Forming Hierarchical Spinel Layer with Ni Gradient Concentration

Li-Rich Li[Li1/6 Fe1/6 Ni1/6 Mn1/2 ]O2 (LFNMO) Cathodes: Atomic Scale Insight on the Mechanisms of Cycling Decay and of the Improvement due to Cobalt Phosphate Surface Modification

Li‐Rich Li[Li1/6Fe1/6Ni1/6Mn1/2]O2 (LFNMO) Cathodes: Atomic Scale Insight on the Mechanisms of Cycling Decay and of the Improvement Due to Cobalt Phosphate Surface Modification

Direct Evidence of Antisite Defects in LiFe0.5Mn0.5PO4via Atomic-Level HAADF-EELS

Li-Rich Li[Li 1/6 Fe 1/6 Ni 1/6 Mn 1/2 ]O 2 (LFNMO) Cathodes: Atomic Scale Insight on the Mechanisms of Cycling Decay and of the Improvement due to Cobalt Phosphate Surface Modification.

Insight into the cation migration and surface structural evolution of spinel LiNi0.5Mn1.5O4 cathode material for lithium-ion batteries

Surface Modification Engineering Enabling LiMn x Fe1‐ x PO4 Cathode Against Aggressive Cathode Chemistries for Excellent Performance Lithium‐ion batteries

Operando Imaging of Over-Discharge-Induced Surface Morphology Evolutions of LiMn2O4 Submicron-Sized Particles by Electrochemical High-Speed Atomic Force Microscopy

Unveiling the role of Ni doping in the electrochemical performance improvement of the LiMn2O4 cathodes

Enhanced long-term cyclability in Li-Rich layered oxides by electrochemically constructing a LixTM3-xO4-type spinel shell