High Sensitive and Selective Detection of PFOS with Resonance Light Scattering Technology Based on the Interaction with Victoria Blue B

Chen Xian-ping,Tao Yi,Wu Fei,Liang Jia-man,Zhang Fang,Tan Ke-jun

DOI: https://doi.org/10.3964/j.issn.1000-0593(2017)03-0811-05

2017-01-01

Abstract:This report presents a simple,sensitive and selective victoria blue B (VBB)-b ased resonance light scattering (RLS) assay of perfluorooctane sulfonate (PFOS) .In pH 60 KH2PO4-NaOH buffer solution,VBB can be protonated and reacts with PFOS through electrostatic interactions to produce ionic-association complexes .Simultaneously,the interaction leads to enhanced resonance light scattering intensities greatly,which are characterized with a peak at 277 nm .It is found that the enhanced RLS intensity is proportional to the concentration of PFOS in a range of 005 to 40 μmol·L-1 .The limit of detection is 50 nmol·L-1 .While,under the optimal experimental conditions,almost no change of the resonance light scattering intensity was observed between VBB and perfluorooctane acid (PFOA) which is one kind of representative perfluorinated compounds (PFCs) .The excellent selectivity of PFOS could be due to the hydrophobicity of PFOS higher than PFOA .It is worth noting that the proposed method is cap able of differentiating PFOS and some other PFCs .UV/Vis absorption spectrum an d scanning electron microscope (SEM) image both were investigated to further validate the reaction mechanism .The interference of coexisting foreign substances and the optimum tests of reaction conditions,including pH value,reaction time,experimental temperature and ionic strength,were also investigated .This method has been successfully applied to the determination of PFOS in environmental water samples with RSD ≤1.74％ .The experimental process as followed: In 2 mL colorimetric tube,200 μL pH 60 KH2PO4-NaOH buffer solution,followed by adding 600 μL 20 μmol·L-1 VBB solution,swirl evenly,then ad d the right amount of PFOS solution .After vortex mixing with ultrapure water volume to 2 mL,swirl to mix,stand for 10 min at room temperature .Then the mixture was transferred for RLS measurements and absorption measurement .