Abstract:Production of fibers from nonthermoplastic polymers, such as chitosan, usually requires dissolution with subsequent fiber formation, for instance, via coagulation. Good fiber-forming properties enable simultaneous spinning of multiple fibers into a yarn, which is one of the prerequisites for process scalability. Here, we report a multifilament wet-spinning process that eliminates the use of such volatile organic compounds as methanol and acetone, enhances fiber formation, and allows producing continuous well-separated chitosan fibers after drying. This is achieved by (i) solidification of the extruded solution by alkali and sodium acetate in the coagulation bath and (ii) further stabilization of the fibers by adsorbing the anionic surfactant, sodium dodecyl sulfate. The obtained fibers have a circular cross section and smooth surface. We demonstrate that it is possible to increase fiber breaking tenacity and Young's modulus by applying stretching (draw ratios up to 1.77) or by incorporating cellulose nanofibrils (CNFs, up to 4 wt % based on chitosan) in the spinning solutions. However, the limitation of increased viscosity when adding CNF is needed to be overcome for possible higher reinforcement effects. We demonstrate that fiber breaking tenacity, Young's modulus, and elongation at break can be enhanced even further by increasing the spin dope temperature from 22 to 60 °C, with simultaneously increasing the spin dope solid content to keep the same dope viscosity. The fibers with a maximum breaking tenacity of ca. 10 cN/tex at an elongation at break of ca. 7.5% were obtained.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsapm.0c00562?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsapm.0c00562</a>.Chemical structures of CNF and CNC, microscopy images of chitosan solutions and fibers, rheological data, SEM images, and EDS spectra (<a class="ext-link" href="/doi/suppl/10.1021/acsapm.0c00562/suppl_file/ap0c00562_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Preparation of Carrageenan Fibers with Extraction of Chondrus Via Wet Spinning Process.

A COMPARATIVE STUDY OF CELLULOSE NANOWHISKERS (cnws) AND CELLULOSE NANOFIBERS (Cnfs)

Effect of epichlorohydrin on the wet spinning of carrageenan fibers under optimal parameter conditions

Development of a high-strength carrageenan fiber with a small amount of aluminum ions pre-crosslinked in spinning solution

Rheological and Structural Characterization of Carrageenans during Depolymerization Conducted by a Marine Bacterium Shewanella sp. LE8

Impact of κ-Carrageenan on the Cold-Set Pea Protein Isolate Emulsion-Filled Gels: Mechanical Property, Microstructure, and In Vitro Digestive Behavior

Advanced Extraction Techniques and Physicochemical Properties of Carrageenan from a Novel Kappaphycus alvarezii Cultivar

Improved extraction of carrageenan from red seaweed (Chondracantus canaliculatus) using ultrasound-assisted methods and evaluation of the yield, physicochemical properties and functional groups

Nanofibrous Mats of Rigid Polysaccharides Prepared by Coaxial Electrospinning

Preparation and Characterization of Three Dimensions Chitosan Rods with Biomimetic Layered Structure Similar to Annual Ring

A New Approach for Preparing Chitosan Fibers from a LiOH/urea Solvent System

Ultrasound Depolymerization and Characterization of Poly- and Oligosaccharides from the Red Alga Solieria chordalis (C. Agardh) J. Agardh 1842

Characterization and Gel Properties of Low-Molecular-Weight Carrageenans Prepared by Photocatalytic Degradation

From Spinning Process to Physical Properties

Wet Spinning of Chitosan Fibers: Effect of Sodium Dodecyl Sulfate Adsorption and Enhanced Dope Temperature

Extraction and Characterization of Pectic Polysaccharides from Chaenomeles Sinensis Fruit by Hot Compressed Water

A method for top down preparation of chitosan nanoparticles and nanofibers.

Preparation of alginate–chitosan fibers with potential biomedical applications

Preparation and Characterization of Cellulose Fiber/chitosan Composites

Spinning Process of Chitosan Fiber with Low Concentration of Formic Acid Solution and its Characteristics