Abstract:Microporous- and mesoporous-activated carbons were produced from longan seed biomass through physical activation with CO2 under the same activation conditions of time and temperature. The specially prepared mesoporous carbon showed the maximum porous properties with the specific surface area of 1773 m2/g and mesopore volume of 0.474 cm3/g which accounts for 44.1% of the total pore volume. These activated carbons were utilized as porous adsorbents for the removal of methylene blue (MB) from an aqueous solution and their effectiveness was evaluated for both the adsorption kinetics and capacity. The adsorption kinetic data of MB were analyzed by the pseudo-first-order model, the pseudo-second-order model, and the pore-diffusion model equations. It was found that the adsorption kinetic behavior for all carbons tested was best described by the pseudo-second-order model. The effective pore diffusivity (De) derived from the pore-diffusion model had the values of 4.657 × 10−7–6.014 × 10−7 cm2/s and 4.668 × 10−7–19.920 × 10−7 cm2/s for the microporous- and mesoporous-activated carbons, respectively. Three well-known adsorption models, namely the Langmuir, Freundlich and Redlich–Peterson equations were tested with the experimental MB adsorption isotherms, and the results showed that the Redlich–Peterson model provided the overall best fitting of the isotherm data. In addition, the maximum capacity for MB adsorption of 1000 mg/g was achieved with the mesoporous carbon having the largest surface area and pore volume. The initial pH of MB solution had virtually no effect on the adsorption capacity and removal efficiency of the methylene blue dye. Increasing temperature over the range from 35 to 55 °C increased the adsorption of methylene blue, presumably caused by the increase in the diffusion rate of methylene blue to the adsorption sites that could promote the interaction frequency between the adsorbent surface and the adsorbate molecules. Overall, the high surface area mesoporous carbon was superior to the microporous carbon in view of the adsorption kinetics and capacity, when both carbons were used for the removal of MB from an aqueous solution.

An Ultra-High Surface Area Mesoporous Carbon Prepared by a Novel MnO-templated Method for Highly Effective Adsorption of Methylene Blue.

Preparation of hydrophilic mesoporous carbon and its application in dye adsorption

Physically Activated Diatomite-templated Carbon with High Porosity for the Adsorption of Methylene Blue

Removal of methylene blue from coloured effluents by adsorption onto SBA-15

The Use of High Surface Area Mesoporous-Activated Carbon from Longan Seed Biomass for Increasing Capacity and Kinetics of Methylene Blue Adsorption from Aqueous Solution

Adsorption studies of methylene blue using mangosteen shell porous biochar as adsorbent

Nanosized Iron Oxide Uniformly Distributed On 3d Carbon Nanosheets: Efficient Adsorbent For Methylene Blue

A facile approach to fabricate porous UMCM-150 nanostructures and their adsorption behavior for methylene blue from aqueous solution

Highly efficient removal of methylene blue from aqueous solution by a novel fishing-net effect of manganese oxide nano-sheets

Facile Preparation of Rod-like MnO Nanomixtures via Hydrothermal Approach and Highly Efficient Removal of Methylene Blue for Wastewater Treatment

Micro-meso Porous Biocarbons Derived from a Typical Biopolymer with Superior Adsorption Capacity for Methylene Blue Dye and High-Performance Supercapacitors

Highly Effective Adsorption of Cationic and Anionic Dyes on Magnetic Fe/Ni Nanoparticles Doped Bimodal Mesoporous Carbon.

Efficient Removal of Methylene Blue from Aqueous Solutions Using a High Specific Surface Area Porous Carbon Derived from Soybean Dreg

Fabrication of Reusable Carboxymethyl Cellulose/Graphene Oxide Composite Aerogel with Large Surface Area for Adsorption of Methylene Blue

Adsorption of Methylene Blue by Porous Ceramics Prepared from Electrolytic Manganese Residues

Porous Graphene Oxide-Based Carbon Artefact with High Capacity for Methylene Blue Adsorption

Honeycomb-like Structure-Tunable Chitosan-Based Porous Carbon Microspheres for Methylene Blue Efficient Removal.

One-Pot Synthesis of Cellulose/MXene/PVA Foam for Efficient Methylene Blue Removal

Coal Based Magnetic Activated Carbon As a High Performance Adsorbent for Methylene Blue

Porous Carbon Spheres Derived from Waste Ion-Exchange Resins and Research on Adsorption of Methylene Blue

Porous Mn-3[Co(CN)(6)](2)center dot nH(2)O nanocubes as a rapid organic dyes adsorption material