Abstract:In this work, regenerated cellulose films were prepared with an iced dissolution method, while the physical morphologies and crystal types of the products were systematically characterized with scanning electron microscope (SEM), Fourier transform infrared(FTIR), while X-Ray Diffraction (XRD). The results demonstrate that the as-prepared continuous and uniform films are indeed cellulose Ⅱ, whose morphology and crystal type are significantly different from those of the degreased cotton. Moreover, Terahertz time domain system (THz-TDS) and FTIR were employed to measure the THz spectra of the regenerated cellulose films. Accordingly, the THz characteristic peaks for the regenerated cellulose films are experimentally identified for the first time. In addition, the increase of the THz transmittance with the decrease of the wavenumber is attributed to the existence of amorphous components in the regenerated cellulose films. Although the shapes of Far-IR spectra in the range of 100～700 cm-1 are similar, the absorption peaks of the regenerated cellulose films move to lower wavenumbers (blue shift) compared with those of the degreased cotton. Based on this, we developed a new approach to distinguish the allomorphism of cellulose Ⅱ and cellulose Iβ by Far-IR. Particularly, geometry optimization and IR calculation for the crystal structure of cellulose Ⅱ have been successfully processed by Density Functional Theory (DFT) using periodic boundary condition via CASTEP package. The calculated absorption peak positions are in good agreement with those experimentally measured. Consequently, the THz characteristic peaks of the regenerated cellulose films have been systematically and successfully assigned. Theoretical calculations reveal that the peaks at 42 and 54 cm-1 are assigned to the lattice vibration modes coupled with translational mode and rotational mode, respectively. Moreover, the absorption peaks in the range of 68～238 cm-1 are related with the torsion vibration of —CH2OH group and deformation vibration of C—H bond and O—H bond, while those in the range of 351～583 cm-1 are assigned to the skeletal vibration of C—O—C bond and pyranoid ring, and those at 611 and 670 cm-1 are originated from the out-of-plane bending vibration of O—H bond. Each absorption peak is involved in more than single vibration mode. The THz spectra presented in this work, together with the theoretical simulations, indicate that the THz responses of regenerated cellulose are closely associated with both its chemical constituents and molecular structure. These results will be helpful not only for better understanding the relations between the molecular structure of the regenerated cellulose and its THz spectrum, but also for providing valuable information for future studies on the physical mechanisms of THz responses of other partially-crystalline polymers and organic biological macromolecules.

Exploring Crystalline Structural Variations of Cellulose During Pulp Beating of Tobacco Stems.

Terahertz time-domain spectroscopy as a novel tool for crystallographic analysis in cellulose: tracking lattice changes following physical treatments

Effects of Different Extraction Methods on Microstructure of Tobacco Cellulose

Experimental and Theoretical Study on Terahertz Spectra for Regenerated Cellulose

Effects of ball milling on the structure of cotton cellulose

Terahertz time-domain spectroscopy as a novel tool for crystallographic analysis in cellulose: cellulose I to cellulose II, tracing the structural changes under chemical treatment

Micro-FTIR combined with curve fitting method to study cellulose crystallinity of developing cotton fibers

Contributions of Crystalline and Noncrystalline Cellulose Can Occur in the Same Spectral Regions: Evidence Based on Raman and IR and Its Implication for Crystallinity Measurements.

A study elucidating the relation between cellulose dissolution and crystallinity after cellulase treatment at different doses

Effect of Compression Combined with Steam Treatment on the Porosity, Chemical Compositon and Cellulose Crystalline Structure of Wood Cell Walls

Use of Fourier Series in X-ray Diffraction (XRD) Analysis and Fourier-Transform Infrared Spectroscopy (FTIR) for Estimation of Crystallinity in Cellulose from Different Sources

Crystalline structure analysis of cellulose treated with sodium hydroxide and carbon dioxide by means of X-ray diffraction and FTIR spectroscopy

Synchrotron X-ray measurements of cellulose in wood cell wall layers of Pinus densiflora in the transmission and reflectance modes. Part 2: results with axial loading

Controllable Synthesis of Carboxymethyl Cellulose and Its Application in Tobacco Sheets

Structural Characteristics Of Plant Cell Wall Elucidated By Solution-State 2d Nmr Spectroscopy With An Optimized Procedure

Structure Development of the Interphase between Drying Cellulose Materials Revealed by In Situ Grazing-Incidence Small-Angle X-ray Scattering

Characterization of cellulose crystallinity after enzymatic treatment using Fourier transform infrared spectroscopy (FTIR)

AFM Study of Crystalline Cellulose in the Cell Walls of Straw

Structural Evolution of Cellulose from Bamboo Fibers and Parenchyma Cells during Ionic Liquid Pretreatment for Enhanced Hydrolysis

Investigation of the structural variations of cellulose microcrystals obtained after acid hydrolysis of waste cotton: a statistical approach

Optimizing crystal transitions in low-temperature, low-concentration NaOH solutions to prepare cellulose I and II composite materials