Abstract:Environmental pollution by heavy metal ions has received worldwide attention due to their long-term toxicity, non-biodegradability and accumulation in living organisms. Mesoporous calcium-silicate material (MCSM), a cost-effective sorbent synthesized from the desilication liquor of coal fly ash, has been tested its potential for the removal of Cd(II), Cr(III), Ni(II) and Pb(II) from acidic solutions. The effect of initial concentration, m/V ratios, solution pH and ionic strength on the sorption was investigated, and the performance of the material on the removal of heavy metals from simulated wastewater was evaluated. At a m/V ratio of 2g L-1, the maximum sorption capacity of MCSM for metals follows the order: Cd(II)≈Ni(II) (5.52 mmol g-1) > Cr(III) (2.88 mmol g-1) > Pb(II) (2.17 mmol g-1). However, the capacity for Cr(III) significantly decreased with comparatively higher metal concentration due to the strong hydration of Cr(III) which destroyed the crystalline phase of material. The initial concentration had a limited positive effect on the sorption, and the removal efficiency of metals only maintained at a relatively higher level with m/V ratios of up to 2 – 5g L-1. At a low m/V ratio (0.75g L-1), sorption was significantly influenced by solution pH and competition cations under strongly acidic conditions (pHinitial= 2), and the adverse effect disappeared when solution pHinitial ≥3. At an m/V ratio of 5g L-1, the removal efficiency of metals maintained in the range of 96.2 – 100.0% varied with different heavy metal ions. Considerable uptake of Zn(II), Mn(II), Fe(III) and Cu(III) by MCSM was also observed in the simulated wastewater, and the 8 metal ions (each 0.001M) were efficiently removed and the remaining metal concentration < 0.1mg L-1 (except remaining Ni(II) concentration < 1.0mg L-1) at an m/V ratio of 20g L-1. The mechanism responsible for the sorption included surface complexation, ion exchange, and probably precipitation at a high m/V ratio (20g L-1). Ion exchange with Ca(II) in MCSM occurred when m/V ratios ≥ 2g L-1(42.1 – 89.6% for m/V = 2 – 5g L-1), whereas surface complexation would probably occur when m/V ratios less than 1g L-1 due to its structural damage by extensive dissolution to form crosslinked structure which resembles vitreous silica. The results suggest that MCSM has the potential for use as an effective and low-cost sorbent for removing hazardous metal ions from wastewater. Besides, MCSM is suitable for use as a substitute of cement and disposed by inexpensive solidification/stabilization technique after being used as a sorbent. Such a process is helpful for the simultaneous realization of the reutilization of coal fly ash and the removal of toxic metals from wastewater.

Novel Synthesis of Cyano-Functionalized Mesoporous Silica Nanospheres (MSN) from Coal Fly Ash for Removal of Toxic Metals from Wastewater.

Coal Fly Ash-Derived Mesoporous Calcium-Silicate Material (mcsm) for the Efficient Removal of Cd(Ii), Cr(Iii), Ni(Ii) and Pb(Ii) from Acidic Solutions

Preparation of Amidoxime-Functionalized Mesoporous Silica Nanospheres (Ami-Msn) from Coal Fly Ash for the Removal of U(VI).

Leaching of Heavy Metals from MSWI Fly Ash: Experiments Vs. Simulation

Synthesis of a Novel Magnetic Nano-Zeolite and Its Application As an Efficient Heavy Metal Adsorbent

Synthesis of Floral-Shaped Nanosilica from Coal Fly Ash and Its Application for the Remediation of Heavy Metals from Fly Ash Aqueous Solutions

Synthesis of porous materials by the modification of coal fly ash and its environmentally friendly use for the removal of heavy metals from wastewater

Novel Mesoporous Organosilica Nanoparticles with Ferrocene Group for Efficient Removal of Contaminants from Wastewater

A novel green synthesis of MnO2-Coal composite for rapid removal of silver and lead from wastewater

Efficient removal of heavy metal ions from wastewater and fixation of heavy metals in soil by manganese dioxide nanosorbents with tailored hollow mesoporous structure

Superior adsorption performance of graphitic carbon nitride nanosheets for both cationic and anionic heavy metals from wastewater

Adsorptive Removal of Cr3+, Cu2+, and Ni2+ Ions by Magnetic Fe3O4@alkali-treated Coal Fly Ash

Assessment of heavy metals mobility and correlative recovery and decontamination from MSWI fly ash: Mechanism and hydrometallurgical process evaluation

Engineering and Optimization of Nano- and Mesoporous Silica Fibers Using Sol–gel and Electrospinning Techniques for Sorption of Heavy Metal Ions

Novel magnetic renewable Ni0.85Se/g-C3N4 material for highly efficient removal of elemental mercury from coal-fired flue gas

Novel Design of Microsphere Adsorbent for Efficient Heavy Metals Adsorption

Hydrothermal N-doping, magnetization and ball milling co-functionalized sludge biochar design and its selective adsorption of trace concentration sulfamethoxazole from waters

Fabrication and Application of Low-Cost Thiol Functionalized Coal Fly Ash for Selective Adsorption of Heavy Toxic Metal Ions from Water

Effect of Nano Silica on Solidification/stabilization of Heavy Metal in Alkali-Activated MSWI Fly Ash Solidified Body

Possibility of Removing Cadmium Pollution from the Environment Using a Newly Synthesized Material Coal Fly Ash

Stability of Mercury on a Novel Mineral Sulfide Sorbent Used for Efficient Mercury Removal from Coal Combustion Flue Gas.