Abstract:Partially premixed compression ignition in a diesel engine is a combustion mode between diffusion combustion and homogeneous charge compression ignition combustion, the combustion controllability and the emission performances of which are close to those of a homogeneous charge compression ignition combustion engine; the mixing period plays a key role in realizing partially premixed compression ignition, and a long premixed process before combustion is necessary to make the fuel and air mix well. Partially premixed compression ignition combustion in a boosted six-cylinder heavy-duty diesel engine is realized by adjusting the injection timing and the rate of exhaust gas recirculation based on a single injection. The effects of the injection timing, the exhaust gas recirculation rate and the load rate on the combustion and the heat release pattern are studied. The factors which influence the mixing period and the ignition delay and its regularity are researched. Endoscope technology and the two-colour method are also used to gain an insight into partially premixed compression ignition combustion. The results show that both early injection and late injection have a long mixing period, which helps to form a more homogeneous mixture, and no diffusion combustion is found in the heat release rate curves. Premixed combustion and low-temperature combustion are the key factors in reducing the particulate matter emissions and nitrogen oxide emissions simultaneously. However, the low-temperature combustion and the dilute mixture may lead to incomplete combustion; consequently, for relatively late-injection conditions, the hydrocarbon and carbon monoxide emissions increase dramatically and the fuel consumption becomes worse. In these partially premixed combustion patterns, the effect of the injection pressure on the particulate matter and nitrogen oxide emissions is not clearly observable. At lower load rates, partially premixed compression ignition combustion displays a low-temperature and a high-temperature two-stage heat release. When the engine load rate is increased to 50%, diffusion combustion appears in the early-injection modes, which leads to higher nitrogen oxide and particulate matter emissions.

Review of the Progress in Homogeneous Charge Compression Ignition Combustion

Research and Development of Homogeneous Charge Compression Ignition Combustion Technology

Homogeneous Charge Compression Ignition (HCCI) Combustion: Combustion Process and Control Strategies

Computational Analysis of Ammonia-Hydrogen Blends in Homogeneous Charge Compression Ignition Mode of Engine Operation

Recent Progress on Research and Development of HCCI Engine

Combustion Stability of Diesel-Fueled Hcci

Effects of engine load, inlet air temperature, valve overlap and EGR on diesel HCCI engine

Study of Diesel-Fuelled Homogeneous Charge Compression Ignition Combustion by In-Cylinder Early Fuel Injection and Negative Valve Overlap

Analysis of homogeneity factor for diesel PCCI combustion control

An Experiment Study of Homogeneous Charge Compression Ignition Combustion and Emission in A Gasoline Engine

Present and Future of Premixed Compression Ignition Engines

An Experimental Investigation of Optimizing Control of Compound Charge Compression Ignition(CCCI)Combustion in an Engine Fueled with DME

Study of HCCI-DI combustion and emissions in a DME engine

Experimental Study on Compound Hcci (homogenous Charge Compression Ignition) Combustion Fueled with Gasoline and Diesel Blends

Comparison of Mixture Formation in Two Combustion Modes in Directly-Injection Diesel

New Gasoline Homogeneous Charge Compression Ignition Combustion System Using Two-State Direct Injection and Assisted Spark Ignition

Search for the Optimizing Control Method of Compound Charge Compression Ignition (ccci) Combustion in an Engine Fueled with Dimethyl Ether

Combustion and Emission Characteristics of Homogeneous Charge Induced Ignition Engines

Investigation of the Combustion and Emission Characteristics of Partially Premixed Compression Ignition in A Heavy-Duty Diesel Engine

Controlling of Gasoline HCCI Combustion Phase and Transient Operation

Effects of mixing and chemical parameters on homogeneous charge induced ignition combustion based on a light-duty diesel engine with ultra-Low NOx and soot emissions and high thermal efficiency