Assessment of the predictive capabilities of various turbulence models for the simulation of rotating stall in the centrifugal pump impeller

Sang Hwan Park,Gong Hee Lee,Dong Kim,Kyoungsik Chang
DOI: https://doi.org/10.1007/s12650-024-00998-8
IF: 1.7
2024-05-01
Journal of Visualization
Abstract:The rotating stall generated by the centrifugal pump impeller reduces efficiency and causes severe flow fluctuations and noise due to surging. In the present work, the six-bladed impeller in the centrifugal pump was simulated by RANS, LES, and Hybrid RANS/LES turbulence models using ANSYS CFX. The turbulence models considered were the Shear Stress Transport (SST), Detached Eddy Simulation (DES), Stress-Blended Eddy Simulation (SBES), Scale Adaptive Simulation (SAS), and Wall-Adapted Local Eddy-viscosity (WALE). The design load condition and the quarter-load condition were applied for the boundary conditions, and the experimental results were compared and analyzed using velocity profile and turbulent kinetic energy at the impeller mid-height. Under the design load condition, all turbulence models predicted results similar to the experimental results. In the off-design load condition, LES predicted the experimental value most accurately, followed by SST-RM of RANS with high accuracy, and the hybrid RANS/LES model showing lower prediction accuracy; SBES predicted excessive recirculation flow. However, if sufficient grid resolution is achieved, hybrid RANS/LES model can simulate the rotating stall under the off-design flow condition than RANS models. Both DES and SAS model show relatively low mesh dependent results with acceptable accuracy.
computer science, interdisciplinary applications,imaging science & photographic technology
What problem does this paper attempt to address?