Abstract:In order to obtain a fibrous biofilm carrier material with a good water purification effect, the biofilm carrier of PAN and PAN-PEO (mass ratio 9:1) was prepared by the electrospinning process, and the performance differences between the fabric biofilm carriers of PAN, PAN-PEO (mass ratio 9:1), and blank non-woven fabric, including the structure of biofilm carriers (surface morphology, specific surface area, and porosity), surface wettability (water contact angle and water absorbance) and membrane hanging ratio, were tested through various characterization methods. The experimental results show that the nanofiber membrane of PAN and PAN-PEO (mass ratio 9:1) prepared by the electrospinning process has a diameter of 75–375 nm, a specific surface area of 19.2 m2/g, and a porosity of 80%. The fiber diameter of non-woven fabric is in the micrometer range, with a specific surface area of 0.3659 m2/g and a porosity of 60%. This indicates that the nanofiber biofilm of PAN and PAN-PEO (mass ratio 9:1) prepared by electrospinning belongs to the carrier with a small diameter, high specific surface area, and high porosity, which can provide more attachment sites and pores for micro-organisms and is more conducive to their attachment in wastewater treatment. At the same time, the water contact angles of PAN and PAN-PEO (mass ratio 9:1) are 27.97° and 18°, respectively, and the water absorption of both reached 300%. The water contact angle of non-woven fabric is 93.32°, and the water absorption rate is only 75%. This shows that the nanofiber biofilms of PAN and PAN-PEO (mass ratio 9:1) prepared by electrospinning effectively improve the infiltration of the carrier in sewage. Finally, under the same conditions, bacterial growth and biofilm growth experiments were conducted on the nanofiber biofilm carriers of PAN and PAN-PEO (mass ratio 9:1) and the biofilm carriers of non-woven fabric. It was found that the effectiveness of the PAN and PAN-PEO (mass ratio 9:1) nanofiber biofilm carrier was significantly higher than that of non-woven fabric in treating wastewater. After 3 days of bacterial cultivation, the membrane hanging ratio of the PAN nanofiber biofilm carrier was 90.36%, the membrane hanging ratio of the PAN-PEO (mass ratio 9:1) nanofiber biofilm carrier was 82.04%, and the membrane hanging ratio of the non-woven fabric biofilm carrier was only 27.32%. After 15 days of bacterial cultivation, the membrane hanging ratio of the PAN nanofiber biofilm carrier was 147.52%, the membrane hanging ratio of the PAN-PEO (mass ratio 9:1) nanofiber biofilm carrier was 147.52%, and the membrane hanging ratio of the non-woven fabric biofilm carrier was 110.53%.

Time-Gradient Nitric Acid Modification of CF Biofilm-Carrier and Surface Nature Effects on Microorganism Immobilization Behavior in Wastewater

Nitrate Effects on Chromate Reduction in a Methane-Based Biofilm.

Nitric Acid-Treated Carbon Fibers with Enhanced Hydrophilicity for Candida tropicalis Immobilization in Xylitol Fermentation

Effect of Polyaniline and Graphene Oxide Modified Carbon Felt on Adsorption and Immobilization of Acidithiobacillus Ferrooxidans.

A novel surface treatment of carbon fiber with Fenton reagent oxidization for improved cells immobilization and xylitol fermentation

Surface modification of carbon fibers by anodic oxidation

Integration of photo-induced biocidal and hydrophilic antifouling functions on nanofibrous membranes with demonstrated reduction of biofilm formation

Electrospinning preparation and characterization testing analysis of nanofiber biofilms

Effects of acid treatment and plasma micromachining on the surface properties of carbon fibers

Antifouling Potential of Multi-Walled Carbon Nanotubes-Modified Chlorinated Rubber-Based Composites on the Colonization Dynamics of Pioneer Biofilm-Forming Eukaryotic Microbes

Surface modification of polyacrylonitrile nanofiber membrane by Bimetallic organic frameworks for enhanced antibacterial properties

A Comparative Study on the Impact of the Carbon Nanotubes-Modified Polydimethylsiloxane Nanocomposites on the Colonization Dynamics of the Pioneer Biofilm Communities

Regulated Surface Morphology of Polyaniline/Polylactic Acid Composite Nanofibers via Various Inorganic Acids Doping for Enhancing Biocompatibility in Tissue Engineering

Distinct Responses of Biofilm Carbon Metabolism to Nanoplastics with Different Surface Modifications

Enhancing Biofilm Growth in an Integrated Fixed-Film Activated Sludge Process Through Modification of Polypropylene Carriers

Enhance PD/A biofilm formation via a novel biochar/tourmaline modified-biocarriers to treat low-strength contaminated surface water: Initial adhesion and high-substrate microenvironment

Treatment of Nanofiltration Concentrate of Landfill Leachate Using Advanced Oxidation Processes Incorporated with Bioaugmentation

Copolymer Brushes with Temperature-Triggered, Reversibly Switchable Bactericidal and Antifouling Properties for Biomaterial Surfaces.

Influence of Lactic Acid Surface Modification of Cellulose Nanofibrils on the Properties of Cellulose Nanofibril Films and Cellulose Nanofibril–Poly(lactic acid) Composites

A novel acid-responsive polymer coating with antibacterial and antifouling properties for the prevention of biofilm-associated infections

Surface modification of activated carbon fiber and its adsorption for vitamin B1 and folic acid