Abstract:The Raman shift of the nu(3)(SiO4) mode of zircon at -1008 cm(-1) has been observed to vary with the pressure (P) and temperature (7) of the environment. The relationship between the nu(3)(SiO4) peak position and P-T was calibrated in previous work and used to develop a pressure sensor for high P-T experiments, up to 1000 degrees C and 10 GPa, to an accuracy within +/- 50 MPa. This pressure measurement method is valid for zircon grains for which the nu(3)(SiO4) Raman shift occurs specifically at or close to 1008.17 cm(-1) at room temperature (25 degrees C). However, the peak position of nu(3)(SiO4) for some zircon grains may shift to a lower or higher wavenumber under ambient conditions, mainly due to the chemical composition of the grains. This may cause substantial deviation in the measured pressures. In the present study, we recalibrated the pressure sensor by determining the position of the nu(3)(SiO4) peak for zircon grains with different chemical compositions at given P-T conditions and developed a model applicable to both natural and synthetic zircon samples. All the zircon samples considered were found to have a universal nu-T relationship when the nu(3)(SiO4) wavenumbers under ambient conditions were calibrated to the same position. Based on this relationship, the temperature-induced wavenumber shift of nu(3)(SiO4) can be expressed as Delta nu(T) (cm(-1)) = 8.00 x 10(-9) x (T-3 - T-o(3))- 2.00 x 10(-5) x (T2 - T-o(2))- 2.78 x 10(-2) x (T - T-o), where T and T-0 are the target and room temperatures, respectively. In addition, the pressure-induced wavenumber shift of nu(3)(SiO4) can be calculated using Delta nu(P) (cm(-1)) = Delta nu - Delta nu(T), where Av is the total frequency shift between the target and ambient P-T conditions. By the linear regression of the experimental results, the global slope (partial derivative nu/partial derivative P)(T) was determined to be 5.91 x 10(-3) cm(-1)/MPa. In addition, high P-T experiments performed in isochoric systems using a hydrothermal diamond anvil cell (HDAC) showed that the cross-derivative term (partial derivative(2)nu/partial derivative P partial derivative T) was equal to zero, which is the same as the previous study. The revised method was used to determine the pressures inside a fused silica capillary capsule (FSCC) containing a NaCl solution. The pressures determined from the zircon Raman spectra (P-zr) were compared with those calculated using the equation of state (P-Eos) of a NaCl-H2O system. The determined P-Zr and P-Eos values agreed well for temperatures lower than similar to 500 degrees C. However, P. was significantly lower than P-Eos at higher temperatures due to the thermal expansion of the FSCC, i.e., the expansion of the sample chamber under the high internal pressures when the silica glass softened at high temperatures. The revised method was programmed in a Microsoft EXCEL spreadsheet and is presented in the Appendix B.

Simultaneous compression of NaCl, Au, and ruby: toward mutually consistent pressure scales

Toward an Internally Consistent Pressure Scale

Invited article: High-pressure techniques for condensed matter physics at low temperature

Measurement of Multiple Physical Parameters of Dense Gaseous Hydrogen-Deuterium Mixture under Double-Shock Compression: Evaluating Theoretical Models from Multiple Views

Quasi-hydrostatic Compression of Ruby to 500 Kbar

Hydrostaticity of pressure-transmitting media for high pressure infrared spectroscopy

Raman Spectra Based Pressure Calibration of the Non-Gauge Sapphire Anvil Cell at High Temperature and High Pressure

Lattice Dynamics and the High Pressure Equation of State of Au

Optical Calibration of Pressure Sensors for High Pressures and Temperatures

A Critical Evaluation of Pressure Scales at High Temperatures by in Situ X-ray Diffraction Measurements

In situ synchrotron X-ray diffraction with laser-heated diamond anvil cells study of Pt up to 95 GPa and 3150 K

Stability Of Ruby In Solid Hydrogen At Megabar Pressures

Reassessment of the Zircon Raman Spectroscopic Pressure Sensor and Application to Pressure Determination of Fused Silica Capillary Capsule

Equation Of State Of Solid Hydrogen And Deuterium From Single-Crystal X-Ray-Diffraction To 26.5 Gpa

Calibration of the Ruby Pressure Gauge to 800 Kbar under Quasi‐hydrostatic Conditions

Establishing gold and platinum standards to 1 terapascal using shockless compression

Specific Volume Measurements of Cu, Mo, Pd, and Ag and Calibration of the Ruby R1 Fluorescence Pressure Gauge from 0.06 to 1 Mbar

Evaluation of Pt and Au Pressure Scales Based on MgO Absolute Pressure Scale

All-optical method to directly measure the pressure-volume-temperature equation of state of fluids in the diamond anvil cell

X-ray diffraction of ruby (Al2O3:Cr3+) to 175 GPa