Abstract:This paper presents the results of a systematic comparative study of the dynamic thermomechanical response of Ti–6Al–4V alloys with three different microstructures. Two of the alloys are produced by the hot isostatically pressed technique using rapidly solidified granules, with one alloy milled prior to hot pressing. Experiments are performed over a broad range of strain rates, 10−3–7000s−1, and initial temperatures, 77–1000 K. Depending on the test temperature, compressive strains of 10–60% are achieved. The microstructure of the undeformed and deformed specimens is investigated, using optical microscopy. The dependence of the flow stress on the temperature and the strain rate is examined for various strains and it is related to the corresponding material microstructure. The results show that adiabatic shearbands develop at high strain rates, as well as at low strain rates and high temperatures. Depending on the test temperature, shearbands initiate once a sample is deformed to suitably large strains. The flow stress is more sensitive to temperature than to the strain rate. Based on these results and other published work, the thermally activated mechanisms associated with the dislocation motion are identified. The physically based model proposed by Nemat-Nasser and Li (1997) for OFHC copper, is suitably modified and applied to this class of titanium alloys. In the absence of dynamic strain aging, the model predictions are in good accord with the experimental results. Comparing the results for the three considered Ti–6Al–4V alloys, with different microstructures, it is found that the initial microstructural features affect only the magnitude of the threshold stress and the athermal part of the flow stress, but not the functional dependence of the thermally activated part of the flow stress on the temperature and the strain rate.

A Novel Approach to Testing the Dynamic Shear Response of Ti-6Al-4V

On the Dynamic Shear Failure of Ti-6Al-4V in Different Test Specimen Geometries

Instability Analysis and Rate-Dependent Failure Criteria for Adiabatic Shear Band Propagation of Ti-6al-4v

Dynamic Shear Fracture Toughness and Failure Characteristics of Ti–6Al–4V Alloy under High Loading Rates

Dynamic Shear Deformation and Failure of Ti-6Al-4V and Ti-5Al-5Mo-5V-1Cr-1Fe Alloys

Dynamic Behavior of TB6 Titanium Alloy under Shear-Compression Loading

Plastic Behavior and Failure Mechanism of Ti-6Al-4V under Quasi-Static and Dynamic Shear Loading

Microstructure and Mechanical Properties of Laser Solid Formed Ti-6Al-4V Alloy Under Dynamic Shear Loading

An Investigation of Dynamic Mechanical Behaviour of Ti6al4v Titanium Alloy at Room Temperature

Analysis of Adiabatic Shearing Phenomenon and Dynamic Mechanical Performance on TA-6 of α-Titanium Alloy

Shear characteristics and failure mechanism of laser metal deposition GH4169 at different strain rates

Adiabatic Shear Fracture in Ti-6Al-4V Alloy

A Novel Method in Dynamic Shear Testing of Bulk Materials Using the Traditional SHPB Technique

Dynamic Response of Conventional and Hot Isostatically Pressed Ti–6Al–4V Alloys: Experiments and Modeling

Dynamic tensile properties of a single crystal Nickel-base superalloy at high temperatures measured with an improved SHTB technique

Shear behavior of TC4 alloy under dynamic loading

The Effects of Microstructure on the Dynamic Mechanical Response and Adiabatic Shearing Behaviors of a Near-α Ti-6Al-3Nb-2Zr-1Mo Alloy

Dynamic compressive properties and underlying failure mechanisms of selective laser melted Ti-6Al-4V alloy under high temperature and strain rate conditions

Some Experiments on Adiabatic Shear Failure

High strain rate mechanical behavior of Ti-6Al-4V with micro–macro correlation under compressive loading

Dynamic Shear Deformation and Failure of Ti-5Al-5Mo-5V-1Cr-1Fe Titanium Alloy