Pressure Effect on the Electronic Structure of Iron in (mg,fe)(si,al)o3 Perovskite: a Combined Synchrotron Mössbauer and X-ray Emission Spectroscopy Study Up to 100 GPa

J. Li,W. Sturhahn,J. M. Jackson,V. V. Struzhkin,J. F. Lin,J. Zhao,H. K. Mao,G. Shen
DOI: https://doi.org/10.1007/s00269-006-0105-y
IF: 1.748
2006-01-01
Physics and Chemistry of Minerals
Abstract:We investigated the valence state and spin state of iron in an Al-bearing ferromagnesian silicate perovskite sample with the composition (Mg 0.88 Fe 0.09 )(Si 0.94 Al 0.10 )O 3 between 1 bar and 100 GPa and at 300 K, using diamond cells and synchrotron Mössbauer spectroscopy techniques. At pressures below 12 GPa, our Mössbauer spectra can be sufficiently fitted by a “two-doublet” model, which assumes one ferrous Fe 2+ -like site and one ferric Fe 3+ -like site with distinct hyperfine parameters. The simplest interpretation that is consistent with both the Mössbauer data and previous X-ray emission data on the same sample is that the Fe 2+ -like site is high-spin Fe 2+ , and the Fe 3+ -like site is high-spin Fe 3+ . At 12 GPa and higher pressures, a “three-doublet” model is necessary and sufficient to fit the Mössbauer spectra. This model assumes two Fe 2+ -like sites and one Fe 3+ -like site distinguished by their hyperfine parameters. Between 12 and 20 GPa, the fraction of the Fe 3+ -like site, Fe 3+ /∑Fe, changes abruptly from about 50 to 70%, possibly due to a spin crossover in six-coordinate Fe 2+ . At pressures above 20 GPa, the fractions of all three sites remain unchanged to the highest pressure, indicating a fixed valence state of iron within this pressure range. From 20 to 100 GPa, the isomer shift between the Fe 3+ -like and Fe 2+ -like sites increases slightly, while the values and widths of the quadruple splitting of all three sites remain essentially constant. In conjunction with the previous X-ray emission data, the Mössbauer data suggest that Fe 2+ alone, or concurrently with Fe 3+ , undergoes pressure-induced spin crossover between 20 and 100 GPa.
What problem does this paper attempt to address?