Abstract:The water entry at high horizontal speed of double-curvature specimens, reproducing the rear part of the fuselage that first gets in contact with the water during aircraft ditching, is investigated experimentally. Three shapes are analysed, representing different aircraft types. Pressure and load measurements are taken, supported by underwater high-speed visualization. The effects of different horizontal speeds, pitch angles, and curvatures are analysed, while keeping a constant vertical-to-horizontal velocity ratio. It is observed that the longitudinal curvature plays a significant role in the hydrodynamics, potentially leading to cavitation and ventilation in the rear part of the specimen at high speeds. The transverse curvature affects the pressures and loads both at the front and at the rear, since a lower transverse curvature increases the possibility of the fluid to escape from the sides. An increase in pitch angle results in an increased loading, in terms of both amplitude and distribution. Finally, an increased horizontal speed leads to higher loads at the front but also affects the cavitation and ventilation modalities at the rear. The load scaling for flat plates also applies to these specimens at the front, but the occurrence of cavitation and ventilation invalidates it at the rear. The time evolution of the cavitation region and of the wetted area are examined through advanced image processing techniques and pressure data analysis. The comparison with the geometric intersection area of the specimen with the still water surface provides further insight into the hydrodynamic phenomena during the water entry.

Simulation of Fluid-Solid Interaction on Water Ditching of an Airplane by Ale Method

Model and Numerical Simulations of Water Ditching by FEM-SPH Coupling Method

Multiphase Flow Simulation of Water Entry of a Structure with Complex Geometry Using a Three-Dimensional Parallel Compressible Model

Numerical simulation of different aircraft sub-floor structures during ditching

Numerical Simulation of Water Entry of Two-Dimensional Structures with Complex Geometry Using a CIP-based Model

Numerical Analysis of the Porpoising Motion of a Blended Wing Body Aircraft During Ditching

Numerical Study of Skipping Motion of Blended-Wing–Body Aircraft Ditching on Calm/Wavy Water

Water entry and exit of 2D and axisymmetric bodies

A Three-Dimensional Fictitious Domain Method for the Simulation of Fluid-Structure Interactions

Numerical Simulations of Seaplane Ditching on Calm Water and Uniform Water Current Coupled with Wind

Crash simulations of aircraft fuselage section in water impact and comparison with solid surface impact

Numerical Simulation To The Effect Of Air In Dam-Break Problem

Hydrodynamic analysis of the water landing phase of aircraft fuselages at constant speed and fixed attitude

Computational fluid dynamics-based design optimization of water scooping system in amphibious aircraft by a parallel active learning surrogate model

Numerical Study of Three-Dimensional Water Entry Problems of Complex Structures Using Particle Method

Test and numerical analysis for water entry of elastic cabin from amphibious aircraft

Numerical Study of Air Cushion Effect in Notched Disk Water Entry Process Using Structured Arbitrary Lagrangian–Eulerian Method

Dynamics Simulation of a Fluid-Filled Coupling System Using the ALE Finite Element Method

High-speed ditching of double curvature specimens with cavitation and ventilation

Reliable method of aerodynamic analysis using computational fluid dynamics and scaled models in the development process of a Very Light Airplane

Separation Dynamics of Large-Scale Fairing Section: a Fluid–structure Interaction Study