Reproducibility of in a BiSrCaCu0 superconductor

T. W. Huang,N. C. Wu,M. P. Hung,J. W. Liou,W. N. Wang,S. E. Hsu,P. C. Yao,M. F. Tai,H. C. Ku,T. S. Chin
DOI: https://doi.org/10.1007/BF01174490
IF: 4.5
1989-01-01
Journal of Materials Science
Abstract:The reproducibility of in superconductive BiSrCaCuO is known to be very poor. In our study, the reproducibility was found to depend greatly on preparation conditions. DTA, TGA and powder X-ray diffraction methods were used to study the BiSrCaCuO superconductors prepared by different routes. Resistivity and diamagnetic susceptibility were taken as the measure of superconductivity. It was found that those superconductors prepared from the oxides/carbonates (one-step) process resulted in scattered data which were less reproducible. The two-step synthesis from precalcined precursors of Bi-Sr-O and Sr-Ca-Cu-0 containing mixtures, resulted in a much improved reproducibility with the predominant = 80 K superconducting phase (more than 95%). It was also found that the amount of = 115 K phase tends to decrease after repeated pulverization and sintering, leading to a single 80 K phase state. Compaction of the pulverized powder at a pressure > 4.5 ton cm was found to induce a preferred (00) orientation during sintering.
What problem does this paper attempt to address?