Comparative study of low-cost fluoride removal by layered double hydroxides, geopolymers, softening pellets and struvite

Liangfu Wei,Zhenming Li,Guang Ye,Luuk C. Rietveld,Doris van Halem
DOI: https://doi.org/10.1080/09593330.2021.1946600
IF: 3.475
2021-06-30
Environmental Technology
Abstract:<span>Excessive F<sup>-</sup> in drinking water due to natural and anthropogenic activities is a serious health hazard affecting humans worldwide. In this study, a comparative assessment was made of eight mineral-based materials with advantageous structural properties for F<sup>-</sup> uptake: layered-double-hydroxides (LDHs), geopolymers, softening pellets and struvite. These materials are considered low-cost, for being either a waste or by-product, or can be locally-sourced. It can be concluded that Ca-based materials showed the strongest affinity for F<sup>-</sup> (Ca-Al-CO<sub>3</sub> LDHs, slag-based geopolymer, softening pellets). The Langmuir adsorption capacity of Ca-Al-CO<sub>3</sub> LDHs, slag-based geopolymer and softening pellets was observed to be 20.83, 5.23 and 1.20 mg/g, respectively. The main mechanism of F<sup>-</sup> uptake on Ca-Al-CO<sub>3</sub> LDHs, Mg-Al-Cl LDHs, slag-based geopolymers and softening pellets was found to be sorption at low initial F<sup>-</sup> concentrations (&lt;10 mg/L) whereas precipitation as CaF<sub>2</sub> is proposed to play a major role at higher initial F<sup>-</sup> concentrations (&gt;20 mg/L). Although the softening pellets had the highest Ca-content (96-97%; XRF), their dense structure and consequent low BET surface area (2–3 m<sup>2</sup>/g), resulted in poorer performance than the Ca-based LDHs and slag-based geopolymers. Nevertheless, geopolymers, as well as struvite, were not considered to be of interest for application in water treatment, as they would need modification due to their poor stability and/or F<sup>-</sup> leaching<b>GRAPHICAL </b></span>
environmental sciences
What problem does this paper attempt to address?