Ultraviolet Assists Persulfate Mediated Anodic Oxidation of Organic Pollutant

Haijian Luo,Chaolin Li,Xue Sun,Shuijing Chen,BinBin Ding,Liu Yang
DOI: https://doi.org/10.1016/j.jelechem.2017.06.037
IF: 4.598
2017-01-01
Journal of Electroanalytical Chemistry
Abstract:Hydroxyl radicals (·OH) electrogenerated at anode surface can efficiently eliminate organic pollutants. However, these radicals are rapidly consumed and its action occurs only in the region where it is produced, thus only a portion of ·OH that are generated can be utilized and the degradation efficiency will eventually drop upon extended electrolysis. This paper proposed an alternative electro-oxidation process to avoid the mass transfer limitation and ·OH loss. This approach consists of two parts: (i) in situ electrogeneration of persulfate and (ii) subsequent UV activation. Efficient electro-generation of persulfate and degradation of phenol were obtained simultaneously when the anolyte contains sulfate ion and potassium sulfocyanide. Compared with ·OH mediated oxidation, persulfate mediated oxidation process has a small negative effect initially on the degradation rate of phenol, but then the persulfate effect became positive gradually. Phenol could be rapid eliminated once UV irradiation was added to activate the co-produced persulfate. A two-step mediated oxidation method was employed to further reduce consumed energy and sulfate dosage. Results show that the two-step method could completely eliminate the phenol in the wastewater which volume was ten times as much as that of the anolyte. An analysis of the whole reaction schemes governing this process was also presented. In summary, the persulfate mediated anodic oxidation process can be considered as a suitable and attractive method for maximizing the utilization of the electrochemical technology.
What problem does this paper attempt to address?