Abstract:A microchannel heat sink (MCHS) is known as a heat dissipation device from the miniaturized electronic components and devices due to its capability to dissipate high heat flux from smaller surface area. However, the higher pressure drop and the uneven heat removal along the channel length are the noticeable disadvantages of MCHS. Though there are attempts to address these shortcomings, no existing study has been found to study the effect of positions of microstructures (micro-pin fin and blind holes) and combined effect of micro-pin fins and blind holes under flow boiling condition. Therefore, in the present study, an attempt has been made to logically explain the effect of various arrangements and positions of pin fins and blind holes in the selected twenty-four uniformly distributed stations on the thermohydraulic performance of MCHS through numerically predicted results. The objectives of the study have been attained using the following three analyses, flow boiling, (i) with saturated fluid inlet conditions (inlet Re = 500), (ii) with different inlet subcooling (20, 40, and 60 °C ), and (iii) with different heat flux conditions (100, 150, 200 and 250 W/cm2 ). From the study, it is observed that the pin fin enhances heat transfer in single-phase flow and delays the phase change by disturbing the flow. The blind holes act as nucleation sites and help phase change heat transfer. It is also observed that the ratio of single-phase and two-phase length and arrangement of microstructures in these two regions predominately dominate the heat transfer and fluid flow characteristics of the microchannel heat sink. The optimum performance (maximum heat transfer coefficient and minimum pressure drop) is achieved when twelve pin fins are placed in the upstream half and twelve blind holes are located at the downstream half of the channel. However, design improvement is possible through more computational and experimental analysis.

Investigation Of The Temperature Fluctuation Of Single-Phase Fluid Based Microchannel Heat Sink

Investigation of Temperature Fluctuation Resulted in Dissolved Gas for Single-Phase Microchannel Heat Sink

Experimental Investigation on the Heat Transfer Performance and Evaporation Temperature Fluctuation of a New-Type Metal Foam Multichannel Heat Pipe

Two-phase Flow Oscillation and Distribution in Parallel Channels During R1233zd(E) Subcooled Flow Boiling: A Numerical Study

An Experimental Study of Microchannel and Micro-Pin-Fin Based On-Chip Cooling Systems with Silicon-to-Silicon Direct Bonding.

A Comprehensive Study of a Micro-Channel Heat Sink Using Integrated Thin-Film Temperature Sensors.

On the assessment of the thermal performance of microchannel heat sink with nanofluid

STUDY ON TWO-PHASE FLOW AND TEMPERATURE UNIFORMITY CHARACTERISTICS OF MICROCHANNEL HEAT PIPE

Numerical Study on Heat Transfer Efficiency and Inter-Layer Stress of Microchannel Heat Sinks with Different Geometries

Numerical simulation on variable width multi-channels heat sinks with non-uniform heat source

Fluid flow and heat transfer characteristics of a microstructured microchannel heat sink under flow boiling condition

Numerical Investigations of the Thermal-Hydraulic Characteristics of Microchannel Heat Sinks Inspired by Leaf Veins

Numerical Analysis of Flow Boiling Characteristics of a Single Channel Heat Sink Subjected to Multiple Heat Sources

Simulation of Subcooled Flow Boiling in Manifold Microchannel Heat Sink

Experimental study on thermal performance of water/nano-phase change emulsion through a mini- and micro-channel stacked double-layer heat sink

Oscillating Flow in a Heat Sink with Parallel Micro Channels

Investigation of fluid flow and heat transfer characteristics in a microchannel heat sink with double-layered staggered cavities

Single-phase and Two-phase Flow and Heat Transfer in Microchannel Heat Sink with Various Manifold Arrangements

A Microchannel Heat Sink with Unitary Circular Flow and Short Distance Heat Transfer Mode: Design and Analysis

Numerical Investigation Of Flow Boiling In A Manifold Microchannel Heat Sink With Conjugate Heat Transfer

Single-phase flow and heat transfer in micro-channels