Abstract:This work utilizes a rapid compression machine (RCM) to experimentally quantify autoignition and pre-liminary heat release characteristics for blends of 0 to 30% ethanol by volume into two surrogates (FGF-LLNL and FGF-KAUST) that represent a full boiling range gasoline (FACE-F). Experimental conditions cover pressures from 15 to 100 bar, temperatures from 700 to 1000K, and diluted/stoichiometric and undi-luted/lean fuel loading conditions representative of boosted spark-ignition and advanced compression ignition engines, respectively. Direct comparison is made with previously reported results for FACE-F/E0-E30 blends. A detailed gasoline surrogate chemistry model is also proposed, and chemical kinetic modeling is undertaken using the proposed model to generate chemical insights into the compositional effects and ethanol blending effects. Although experiments show similar qualitative trends between the surrogates, quantitative differences between the surrogates are obvious, where FGF-LLNL displays greater low-temperature reactivity and faster evolution of low-temperature heat release (LTHR) than FGF-KAUST, with such differences being significantly muted by ethanol blending. Flux analyses reveal the compositional effects on surrogate reactivity at the diluted/stoichiometric condition, where n-heptane facilitates first-stage ignition reactivity for FGF-LLNL/E0 by initiating earlier and more rapid OH branching than n-butane for FGF-KAUST/E0. Sensitivity analyses highlight the importance of non-fuel-specific interactions between ethanol and surrogate sub-chemistries in controlling the reactivity of ethanol-blended surrogates. Direct experimental comparisons between the surrogates and FACE-F, as well as between the surrogate/EtOH and FACE-F/EtOH blends highlight the need of high-fidelity surrogates that can fully replicate the target gasoline in properties in-cluding ignition reactivity and LTHR characteristics at extended conditions, as well as their response to ethanol blending. Overall, the model captures the experiments reasonably well. Nevertheless, the model displays increasing disagreement with experiments for the two surrogates at higher levels of ethanol blending, and this is found to be caused primarily by non-fuel-specific interactions between ethanol and surrogate component sub-chemistries. Futhermore, the inadequacy of the kinetic model to capture surrogate-to-surrogate differences at the diluted/stoichiometric condition suggests more physical testing is needed to facilitate more extensive model validation. (C) 2021 Published by Elsevier Inc. on behalf of The Combustion Institute.

A reduced kinetic model for the oxidation of supercritical ethanol/gasoline surrogate blends

A Reduced Kinetics Model for the Oxidation of Transcritical/Supercritical Gasoline Surrogate/Ethanol Mixtures Using Real Gas State Equations

Development of a Reduced Four-Component (Toluene/n-Heptane/iso-octane/ethanol) Gasoline Surrogate Model

A reduced mechanism for the combustion of gasoline-ethanol blend on advanced engine combustion modes

Reduced Chemical Model for Low and High-Temperature Oxidation of Fuel Blends Relevant to Internal Combustion Engines

Autoignition and Preliminary Heat Release of Gasoline Surrogates and Their Blends with Ethanol at Engine-Relevant Conditions: Experiments and Comprehensive Kinetic Modeling

Quantitative Evaluation of Several Chemical Mechanisms for Gasoline Surrogate-Ethanol Blends and Study of Dominant Chemistry under Super-Knock Relevant Conditions

A Reduced Combustion Kinetic Model for the Methanol-Gasoline Blended Fuels on SI Engines

Reduced chemistry for a gasoline surrogate valid at engine-relevant conditions

Numerical simulation of a DISI engine with a reduced chemical kinetic mechanism for gasoline–ethanol blends

An Experimental and Kinetic Modeling Study on the Low-Temperature Oxidation, Ignition Delay Time, and Laminar Flame Speed of a Surrogate Fuel for RP-3 Kerosene

Development of a 5-Component Gasoline Surrogate Model Using Recent Advancements in the Detailed H2/O2/CO/C1-C3 Mechanism for Decoupling Methodology

Construction of a Chemical Kinetic Model of Five-Component Gasoline Surrogates under Lean Conditions

Development of a Detailed Kinetic Model for High-Pressure Ethanol Oxidation in Gas Phase and Supercritical Water

A skeletal mechanism for gasoline surrogates: Development, validation, and CFD application

Probing the Chemical Kinetics of Minimalist Functional Group Gasoline Surrogates

Reduced Chemical Kinetic Models Of C1-C4 Alcohols Using The Alternate Species Elimination Approach

Modeling of autoignition and NO sensitization for the oxidation of IC engine surrogate fuels

Chemical Kinetic Model for Ignition of Three-Component Fuel Comprising Iso-Octane/N-Heptane/Ethanol

Experimental and Numerical Study of Soot Formation in Laminar Coflow Diffusion Flames of Gasoline/ethanol Blends

An Updated Reaction Model for the High-Temperature Pyrolysis and Oxidation of Acetaldehyde