Abstract:Solid-state transformers (SST) are emerging technologies to replace the conventional low-frequency main transformer (MTR) in railway vehicles. In order to isolate the load side from the AC 25 kV high-voltage (HV) side and to reduce the whole size of the SST, HV insulation and high-frequency transformers should be used in DC/DC converters. Furthermore, due to the severe constraint of installation space and difficulty of heat dissipation management in the bottom of railway vehicles, high-power density and minimum transformer loss should be considered. To satisfy such design requirements of the proposed SST for railway vehicles, high efficiency integrated transformers, which inherently have leakage inductance, are proposed for dual-active-bridge (DAB) converters in this paper. In order to obtain appropriate equivalent leakage inductance for the DAB converters, a calculation methodology for the leakage inductance has been introduced and verified by simulation. Two separated winding structures in the center-core are adopted to improve the core loss, and appropriate winding turns with 60 kV HV insulation capability are selected, according to the proposed design procedure of the integrated transformers. In order to compare the proposed transformers with the conventional transformer having additional inductors and to verify the major characteristics of the transformers, two 125 kW proposed transformers and conventional transformers have been built and evaluated by an 250 kW SST module, operating at 10 kHz switching frequency. Under a 125 kW full-load condition, 99.7% transformer efficiency was obtained by the proposed integrated transformers, which are 4.7% smaller and 7.0% lighter than the conventional transformer. As a result, 26°C maximum temperature improvement has been obtained and 60k V HV insulation capability has been satisfied by the proposed integrated transformers.

Leakage Inductance Extraction of High Frequency Isolation Transformer Based on Switching Transient Waveform

Inductance Characteristics Of The High-Frequency Transformer In Dual Active Bridge Converters

Transformer Secondary Leakage Inductance Based ZVS Dual Bridge DC/DC Converter

A novel PCB winding transformer with controllable leakage integration for a 6.6kW 500kHz high efficiency high density bi-directional on-board charger

ZVS Operation of DAB Converter Based on Triple-Phase-shift Modulation Scheme with Optimized Inductor Current

Dual-Transformer-Based DAB Converter with Controllable Integrated Inductances

A Novel Analysis, Design, and Optimal Methodology of High-Frequency Oscillation for Dual Active Bridge Converters With WBG Switching Devices and Nanocrystalline Transformer Cores

Design of Planar Magnetic Element for Three-level DAB Converter

A Simple DC-Offset Eliminating Method of the Series-Inductance Current for the DAB DC–DC Converter

Impact on ZVS Operation by Splitting Inductance to Both Sides of Transformer for 1-Mhz GaN Based DAB Converter

A Leakage Inductance Adjustment Model of Hybrid Winding Arrangement Medium Frequency Transformer

Parasitic Parameter Extraction and Identification Method for HFT Based on DC-DC Converter in EV Application

An Analog-based, Duty Cycle Modulation Method to Remove the DC Bias in the Transformer for a Dual Active Bridge Converter

On the Analysis and Design of High-Frequency Transformers for Dual and Triple Active Bridge Converters in More Electric Aircraft

Magnetic Integration for a Dual Active Bridge Converter Planar Transformer with Accurate Leakage Inductances Estimation

High Efficiency Integrated Transformer Design in DAB Converters for Solid-State Transformers

Leakage Inductance of Power Transformer in High Frequency Switch Mode Power Supply

Dual Coupled Inductors With Controllable Integrated Leakage Inductance and CM Noise Suppression for CF-DAB Converter

An Accurate Calculation Method of Leakage Inductance of High-Frequency Transformer With Litz Wire Winding Considering Irregular Region

Design and Experimental Verification of Three‐Phase Medium‐Frequency Transformers for High‐Power DC‐DC Applications