The movement of golden hamster spermatozoa before and after capacitation.
R. Yanagimachi
DOI: https://doi.org/10.1530/JRF.0.0230193
1970-10-01
Abstract:Epididymal spermatozoa of the golden hamster can be capacitated in vitro in the presence of oviduct fluid from the oestrous female hamster (Yanagimachi & Chang, 1964; Yanagimachi, 1966; Barros & Austin, 1967), follicular fluid from mature ovarian follicles of the hamster (Barros & Austin, 1967; Yanagimachi, 1969a), detoxified bovine follicular fluid (Gwatkin & Andersen, 1969; Yanagimachi, 1969b), and detoxified blood sera of the hamster and some other species (Yanagimachi, 1970). When incubated in media containing these biological fluids, the spermatozoa agglutinate head to head within \m=1/2\hr. About 2\m=1/2\to 3 hr later, agglutinated spermatozoa disperse spontaneously and free spermatozoa show an extraordinarily active movement. In the majority (sometimes, 100%) of these spermatozoa, the acrosomal reaction is in progress or has been completed and the spermatozoa are ready to penetrate the eggs (Yanagimachi, 1969a, b, 1970). This communication reports that the movement of these capacitated spermatozoa is quite different from that of fresh epididymal (uncapacitated) spermatozoa. Spermatozoa were squeezed out of the cauda epididymidis of fertilemales and suspended in Tyrode's solution (35\s=deg\to 37\s=deg\C), the final concentration of the spermatozoa in the solution being about 2 \m=x\107/ml. A sample of the sperm suspension (0\m=.\05to 0\m=.\4ml) was immediately mixed with an equal volume of \g=g\-globulin-freehuman serum (Hyland Laboratory, Los Angeles, Calif.) and incubated at 37\s=deg\C under mineral oil in either a watch glass or a plastic organ culture dish (Falcon Plastics, Los Angeles, Calif). Between 3 and 4 hr after the start of the incubation, by which time the spermatozoa are fully capacitated (Yanagimachi, 1970), one drop of the sperm suspension was gently placed in the centre of four wax dots on a clean slide and covered with a coverslip, both of which were previously coated with silicon. Slight pressure was applied to the coverslip so that the distance between the slide and coverslip became approximately 300 μ. The drop was sealed with mineral oil to prevent evaporation. The preparation was maintained at 37° C by means of an aircurtain incubator (Sega Instruments, White Plains, New York) and examined with dark field or dark medium-phase contrast objectives. Observations were recorded cinematographically on moving film taken at a speed of fifty frames/ sec. Films obtained were projected frame by frame and consecutive positions