Abstract:Autonomous Underwater Vehicle (AUV) is one type of important equipments for conducting ocean exploration missions. The AUV control system typically employs a common communication network to connect various function nodes such as Doppler meter, compass/inertial navigation unit, sonar, water depth sensor, main propulsion, and rudder motor. Each of these function nodes has its own information transmission requirements that need to be served by the limited bandwidth of the common communication network. In order to obtain a good control performance, an elaborate information transmission schedule in the communication network should be planned in such a way that all information transmission requirements in the AUV control system can be satisfied with as less network-induced delay and data packet dropout as possible. This paper proposes a novel network scheduling approach based on the Genetic Algorithm (GA) and the time-triggered architecture for meeting information transmission requirements in the Controller Area Network (CAN) of the AUV control system. The proposed network scheduling approach divides the whole transmission period into a serial of time slices with equal lengths, and defines a large cycle consisting of multiple time slices. For the periodical information transmission, the transmission schedule in one large cycle is determined by solving one nonlinear integer optimization problem with the Genetic Algorithm. This GA-based network scheduling approach maximizes the available bandwidth of each single time slice in all the periodic time slices of the whole schedule period, and aims to achieve a balanced information transmission in the CAN network. Meanwhile, the available bandwidth in each time slice of the whole schedule period is then allocated for the event-triggered information transmission. In this way, the proposed network scheduling approach satisfies the transmission requirements of both periodical and event-triggered information in the AUV. Finally, simulation experiments demonstrate the performance of the proposed GA based network scheduling approach, and verify its performance improvement on an AUV heading motion control using TrueTime toolbox.

A Genetic Algorithm for Packing CAN FD Frame with Real-Time Constraints

A Genetic Algorithm for Minimizing Bandwidth Utilization by Packing CAN-FD Frame

An Integrated Framework for Packing CAN-FD Frames and Assigning Offsets

An Optimized Design of CAN FD for Automotive Cyber-Physical Systems

Balancing Bandwidth Utilization and Interrupts: Two Heuristic Algorithms for the Optimized Design of Automotive CPS

A Hybrid Genetic Algorithm to Optimize Device Allocation in Industrial Ethernet Networks with Real-Time Constraints

Genetic Algorithm Based Resource Management for Cognitive Mesh Networks with Real-time and Non-real-time Services

Genetic Optimization-Based Scheduling In Maritime Cyber Physical Systems

A Bottleneck Detection Algorithm for Complex Product Assembly Line Based on Maximum Operation Capacity

Optimizing Extensibility of CAN FD for Automotive Cyber-Physical Systems.

The Worst-Case Response Time Analysis for FIFO-based Offset Assigned CAN Messages.

A Novel Network Scheduling Approach Based on Genetic Algorithm for Autonomous Underwater Vehicle Control

An Efficient Genetic Algorithm for Multi Agv Scheduling Problem About Intelligent Warehouse

Accounting Information Systems Genetic Algorithms for All-Optical Shared Fiber-Delay-Line Packet Switches

Performance Enhancement of CAN/Ethernet Automotive Gateway with a CAN Data Reduction Algorithm

A Genetic Algorithm for Task Scheduling on Noc Using Fdh Cross Efficiency

An Efficient Packing Algorithm Based on Constraint Satisfaction Problem Technique

Flexible Genetic Algorithm: A Simple and Generic Approach to Node Placement Problems.

An Enhanced Packing Algorithm for FPGA Architectures Without Local Crossbar

A cooperative adaptive genetic algorithm for reentrant hybrid flow shop scheduling with sequence-dependent setup time and limited buffers

An effective hybrid genetic algorithm with flexible allowance technique for constrained engineering design optimization