Abstract:This work aims to apply the multi-objective optimization method to gas turbine part-load energy-saving and NOx (Nitrogen Oxides) emission reduction problem. For power generation gas turbines, energy-saving is based on raising the thermal efficiency of the system. This is always based on regulating the variable geometries of the plant. However, in this process, the combustion condition would be changed, which would further change the NOx pollutant emission level. Therefore, in this paper, the conflict between gas turbine thermal efficiency enhancement and NOx emission reduction is discovered and analyzed with a nonlinear model. To solve this multi-objective optimization problem, GA (Genetic Algorithm), a global optimization algorithm, is applied. The two objectives are thermal efficiency for energy-saving and NOx Emission Index (EINOx) for pollution reduction. The fuel mass flow rate and compressor Inlet Guide Vane (IGV) position are the decision variables. Optimization is conducted for 50% to 90% nominal power levels and 5 °C to 25 °C ambient temperatures. With the non-inferior solutions on the Pareto Front and a trade-off decision, the selected gas turbine optimum working point can be obtained with a nonlinear converter module. For 15 °C, 70% nominal power working condition, increasing the fuel mass flow rate by 0.216% and IGV degree by 10.344% can bring a 46.273% reduction of EINOx, with the cost of a 0.212% decline in the thermal efficiency. The sensitivity analysis of the Pareto Frontiers to power level and ambient temperature is carried out. Then the level of energy-saving is analyzed by calculating the cost of fuel, and a trade-off suggestion is given. In the end, the values of the decision variables and objective functions under three trade-off scenarios are calculated and listed in a table, with which the final solution can be decided conveniently according to practical demands.

A New Method for the Design of Optimal Control in the Transient State of a Gas Turbine Engine

Conceptual Design and Optimization of Scramjet Engines Using the Exergy Method

An Optimum Design Method Based on PSO Algorithm for Neuron Controllers

Optimization on Start-up Process of Steam Turbine in Combined Cycle Generating Units

Design of Transition State Control Method for Civil Aviation Engine Facing NOx Emission Reduction Target

Design of Variable Weight SDRE Control Algorithm for Civil Aeroengine Transition State

Designing method of acceleration and deceleration control schedule for variable cycle engine

Simulation of Optimization of Variable Geometry for a Turbofan Engine of a Missile

Nonlinear Control of Turbofan Engines: an Active Set-Based Method for Performance Optimization

Optimal control for helicopter/turboshaft engine system based on hybrid variable speed

Optimization-based Transient Control of Turbofan Engines: a Sequential Quadratic Programming Approach

Multi-objective performance optimization and control for gas turbine Part-load operation Energy-saving and NOx emission reduction

An adaptive synergetic controller applied to heavy-duty gas turbine unit

Inverse Optimal Adaptive Neural Power Regulation Control for Variable-Speed Wind Turbines with Load Mitigation

Surge-elimination Strategy for Aero-engine Transient Control

Design of Gas Turbine Cooling System Based on Improved Jumping Spider Optimization Algorithm

Optimization of Controllers for Gas Turbine Based on Probabilistic Robustness

Nonlinear Design Method for Improving Aero-Engine Control Performance

A hybrid design method of steady-state throttling control schedules for high-flow variable cycle engine

Research on Integrated Control Method for Helicopter/Turboshaft Engine with Variable Rotor Speed Based on the Error Between Engine Required and Real Output Torque

Development of a Novel Dual-Loop Optimization Method for the Engine Electric Turbocompound System Based on Particle Swarm Algorithm