Abstract:Here we report an optical fiber sensor capable of performing strain-insensitive simultaneous measurement of bending and temperature using a long-period fiber grating (LPFG) inscribed on doubleclad fiber (DCF) with a CO₂ laser at ˜10.6 μm. The LPFG inscribed on DCF, referred to as a DC-LPFG, was fabricated by scanning CO₂ laser pulses on an unjacketed DCF with a specific period. Due to co-directional mode coupling, the fabricated DC-LPFG has discrete attenuation bands widely distributed over hundreds of nanometers. Among these wavelength-dependent loss dips, adjacent two dips with different resonance wavelengths were selected as sensor indicators for the measurement of bending and temperature. For these two indicator dips designated as dips A and B, their bending and temperature responses were investigated in a curvature range of 4.90 to 21.91 m-1 and a temperature range of 30 to 110 °C. With increasing bending applied to the DC-LPFG at room temperature, dips A and B showed different blue shifts. The bending sensitivities of dips A and B were measured to be approximately -0.77 and 0.51 nm/m-1, respectively. Unlike the bending response, they showed red shifts of different amounts with increasing ambient temperature, while the sensor head (i.e., the DC-LPFG) remained straight without any applied bending. The temperature sensitivities of dips A and B were measured to be ˜0.094 and ˜0.078 nm/°C, respectively. Owing to their linear and independent responses to bending and temperature, bending and temperature changes applied to the DC-LPFG could be simultaneously estimated from the measured wavelength shifts of the two indicator dips using their pre-determined bending and temperature sensitivities. Moreover, in a strain range of 0 to 2200 με (step: 200 με), strain-induced spectral variations of dips A and B were also measured, and the strain sensitivities of dips A and B were evaluated as approximately -0.028 and -0.013 pm/με, respectively. These strain-induced wavelength shifts were so small that they had little effect on the measurement results of bending and temperature. Thus, it is concluded that the fabricated DC-LPFG can be employed as a cost-effective sensor head for strain-insensitive separate measurement of bending and temperature.

Concave-lens-like Long-Period Fiber Grating Bidirectional High-Sensitivity Bending Sensor.

Integrated All-Fiber Sensor for Simultaneous Measurements of Curvature and Temperature

Modulation of the Dual Resonant Peaks of a Long-Period Fiber Grating Towards Highly Sensitive Sensing by Means of Polymeric Nanocoatings for Biosensing Applications

Highly Sensitive Vector Bending Sensor Based on an Embedded Multimode D-shaped LPFG.

Two-Axis Bending Sensor Based on Asymmetric Grid Long-Period Fiber Grating

A Vector Bending Sensor Based on a Core-Offset Long Period Fiber Grating Induced by an Arc-Discharge

Angularly Cascaded Long-Period Fiber Grating for Curvature and Temperature Detection

A Wide Range Curvature Sensor Based on Fiber Ring Laser With a Long-Period Fiber Grating

High Sensitivity Chiral Long-Period Grating Sensors Written in the Twisted Fiber

A Long-Period Fiber Grating Sensor Based on a Core-Cladding Misalignment Structure

A chirped long period fiber grating sensor based on micro-helix taper

Curvature and angle sensor based on LP 21 mode reflected by a four-mode fiber Bragg grating

A Simultaneous Measurement Sensor for Temperature and Curvature Based on Congruent Quasi-Helical Long-Period Fiber Grating

Sensitivity-Enhanced Strain Sensor With a Wide Dynamic Range Based on a Novel Long-Period Fiber Grating

Fabrication and Sensing Characteristics of Long-Period Fiber Grating in Capillary Fiber

Temperature self-compensation strain sensor based on cascaded concave-lens-like long-period fiber gratings

An Inline Fiber Curvature Sensor Based on Eccentric Core Fiber and Off-Axis Air Cavity Fabry-Pérot Interferometer

Simultaneous Measurement of Curvature Vector and Temperature Based on Composite Gratings Inscribed on D-Shaped Fiber

Strain-Insensitive Simultaneous Measurement of Bending and Temperature Using Long-Period Fiber Grating Inscribed on Double-Clad Fiber with CO₂ Laser

Fiber-Taper Seeded Long-Period Grating Pair As A Highly Sensitive Refractive-Index Sensor

A Multiparameter Sensor Based on Dumbbell-Shaped Double-Cladding Fiber Structure Cascaded Long Period Fiber Grating