Abstract:Lithium–sulfur (Li–S) batteries are regarded as one of the most promising next-generation battery technologies owing to their ultrahigh energy density up to 2600 W h kg–1 and low cost. However, major challenges still remain in the application of Li–S batteries, such as shuttle effect and sluggish redox kinetics. Herein, it is demonstrated that phosphorus doping can not only significantly improve the polysulfide adsorption but also enhance the catalysis effects of metal–organic framework-derived CoS2 nanoboxes in Li–S batteries. Consequently, a modified separator integrated with P–CoS2 and carbon nanotubes effectively suppresses the polysulfide shuttle and propels the redox kinetics of polysulfides, thus promising higher specific discharge capacity, better rate, and stable cycle performance. Even under the high sulfur loading condition (4.8 mg cm–2), the areal discharge capacity of the cell with the functional separator can still remain at 4.5 mA h cm–2 after 100 cycles at 0.2 C. More importantly, this work may encourage more effort on anion doping for engineering the polar surface of transition-metal compounds to further mediate the interfacial redox chemistry between transition-metal compounds and polysulfides in Li–S batteries.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsami.1c00494?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsami.1c00494</a>.XRD patterns, SEM, TEM images of Co–MOF and CoS2; high-magnification XRD patterns of CoS2 and P-CoS2 in the 2θ range of 30–35°; EDS mapping images of CoS2 and P-CoS2; P 2p XPS spectrum of P-CoS2 after etching; SEM images from the front and the cross-section for the CNT-, CoS2/CNT-, and P-CoS2/CNT-modified separator; digital image of the P-CoS2/ separator and folding and unfolding test of the P-CoS2/ separator; permeation tests of the pristine Celgard, , CoS2/, and P-CoS2/ separators; CV curves of symmetric cells of CNTs with and without Li2S6 at 1 mV s–1; galvanostatic discharge/charge curves of P-CoS2/ at 2.0 C; galvanostatic discharge/charge curves and cycling performance of the P-CoS2 cathode without sulfur for the initial few cycles at 0.1 C; postmortem SEM images and EDS analysis of the lithium foil; postmortem SEM images and EDS analysis of CoS2 and P-CoS2 after 1.0 C cycles; and performance statistics of similar Li–S batteries in the literature (<a class="ext-link" href="/doi/suppl/10.1021/acsami.1c00494/suppl_file/am1c00494_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Effects of O, S, and P in transition-metal compounds on the adsorption and catalytic ability of sulfur cathodes in lithium–sulfur batteries

Balancing Adsorption, Catalysis, and Desorption in Cathode Catalyst For Li–S Batteries

Breaking the Passivation Effect for MnO2 Catalysts in Li-S Batteries by Anion-Cation Doping

Strong Sulfur Binding with Conducting Magnéli-phase Ti(n)O2(n-1) Nanomaterials for Improving Lithium-Sulfur Batteries.

Preparation of Co9S8-Mo2C nanoparticles and their application in lithium-sulfur batteries

Anion Design-Enabled High-Performance Cobalt-Based 3D Conductive Interlayers to Suppress the Shuttle Effect for Lithium–Sulfur Batteries

Catalytic-conversion behavior of MoS2 for polysulfides by nickel introduction and phosphorous-doping in advanced lithium-sulfur batteries

Intrinsic catalytic Sites-Rich Co-doped SnO2 nanoparticles enabling enhanced conversion and capture of polysulfides

P-doped Co9S8 nanoparticles embedded on 3D spongy carbon-sheets as electrochemical catalyst for lithium-sulfur batteries

Effective D–p Orbital Hybridization of Co0.75Fe0.25P Catalysts Enabling High-Rate and Long-Life Lithium‒sulfur Batteries

A Universal Electronic Structure Modulation Strategy: Is Strong Adsorption Always Correlated with High Catalysis?

Establishing Transition Metal Phosphides as Effective Sulfur Hosts in Lithium–Sulfur Batteries through the Triple Effect of "Confinement–Adsorption–Catalysis"

Effect of Heteroatom in Conductive Polymer Coating of Cathode Materials on Electrochemical Performance of Lithium Sulfur Batteries

Single‐Atom Cobalt Catalyst Boosting Reaction Kinetics in Li–Organosulfur Battery

Phosphorus-Doped Metal–Organic Framework-Derived CoS 2 Nanoboxes with Improved Adsorption-Catalysis Effect for Li–S Batteries

Metal–Organic Frameworks with Axial Cobalt–Oxygen Coordination Modulate Polysulfide Redox for Lithium–Sulfur Batteries

Bidirectional catalysis of Co0.4Ni1.6P for Li2S1–2 deposition/decomposition reactions in Li-S batteries

Cobalt-Doping of Molybdenum Disulfide for Enhanced Catalytic Polysulfide Conversion in Lithium-Sulfur Batteries

Tuning of d-p band centers with M-A (M = Co, Ni, Cu; A = N, P, O, Se) co-doped FeS 2 for enhanced Li-S redox chemistry

Nitrogen-doped Carbonaceous Scaffold Anchored with Cobalt Nanoparticles As Sulfur Host for Efficient Adsorption and Catalytic Conversion of Polysulfides in Lithium-Sulfur Batteries

Modulating Electronic Structure with Copper Doping to Promote the Electrocatalytic Performance of Cobalt Disulfide in Li–O2 Batteries