Abstract:Phase-change memory (PCM) and resistive memory (RRAM) are promising alternatives to traditional memory technologies. However, both PCM and RRAM suffer from limited write endurance. Wear-leveling (WL) techniques are essential to extend the lifetime of these memories before experiencing endurance faults. Beyond the additional usage afforded by WL, row-sparing and focused error correction can extend the lifetime further after wear faults appear. Unfortunately, the need for extended WL techniques continues to become more pressing as scaling exacerbates process variation. Similarly, scaling causes challenges such as more severe noise and crosstalk to traditional DRAM.In this paper, we propose novel fault-aware WL schemes to allocate write frequencies according to the strength of the rows and handle the imbalance of writes in columns. We use runtime detection schemes to identify weak rows and protect them prior to wear out. In particular, row-level WL, aka RETROFIT, leverages the spare rows provided for redundancy to be used strategically to guard against early cell wear out. RETROFIT is compatible with error correction schemes that guarantee to mitigate hard faults and error-correcting codes (ECC). Rather than discard retired rows, when any spare row completely replaces a retired row, we retarget the retired row to assist with column sparing. It becomes a group of Page Protecting Pointers (PPPs), which utilizes otherwise discarded error correction potential to further enhance the leveling ability of RETROFIT. To relieve column-level imbalance, we apply idle error correction bits before they are used to reduce average bit flips. The evaluation demonstrates that RETROFIT and enhanced RETROFIT with the PPPs improve lifetime by as much as 0.64× and 5.4× in the average case, respectively, over state-of-the-art row-level method while also reducing area overhead. In the worst-case scenario, these improvements further increase to 2.6× and 16.0×. Combined with the proposed column-level WL, enhanced RETROFIT realizes an overall 1.5× memory lifetime improvement over the perfectly uniform wear-leveling with equal storage overhead.

Protect Non-Volatile Memory from Wear-out Attack Based on Timing Difference of Row Buffer Hit/miss.

The Impact of Non-linear NVM Devices on In-Memory Computing

Realizing Extreme Endurance Through Fault-aware Wear Leveling and Improved Tolerance.

Wear-Leveling Aware Page Management for Non-Volatile Main Memory on Embedded Systems.

Redesign the Memory Allocator for Non-Volatile Main Memory.

Toss-up Wear Leveling

Architecting Non-Volatile Main Memory to Guard Against Persistence-based Attacks

SoftWear: Software-Only In-Memory Wear-Leveling for Non-Volatile Main Memory

A Software-hardware Collaborating Framework for Wear Leveling on Phase Change Memory

CoPA: Cold Page Awakening to Overcome Retention Failures in STT-MRAM Based I/O Buffers

A Collaborative Defense Against Wear out Attacks in Non-Volatile Processors

Increasing Endurance and Security of Phase-Change Memory with Multi-Way Wear-Leveling

Exploiting Narrow-Width Values for Improving Non-Volatile Cache Lifetime

Exploring Dynamic Redundancy to Resuscitate Faulty PCM Blocks

A Read-Write Aware Replacement Policy for Phase Change Memory

Exploit Imbalanced Cell Writes to Mitigate Write Disturbance in Dense Phase Change Memory

An efficient run-time encryption scheme for non-volatile main memory

A Software-based NVM Emulator Supporting Read/Write Asymmetric Latencies

Memory That Never Forgets: Emerging Nonvolatile Memory and the Implication for Architecture Design

Comprehensive Study of Security and Privacy of Emerging Non-Volatile Memories

A Low Active Leakage and High Reliability Phase Change Memory (PCM) Based Non-Volatile FPGA Storage Element