Abstract:The influence of fluid–structure interaction on cloud cavitation about a hydrofoil is investigated by comparing results from a relatively stiff reference hydrofoil, presented in Part 1, with those obtained on a geometrically identical flexible hydrofoil. Measurements were conducted with a chord-based Reynolds number $Re=0.8\times 10^{6}$ for cavitation numbers, $\unicode[STIX]{x1D70E}$ , ranging from 0.2 to 1.2 while the hydrofoil was mounted at an incidence, $\unicode[STIX]{x1D6FC}$ , of $6^{\circ }$ to the oncoming flow. Tip deformations and cavitation behaviour were recorded with synchronised force measurements utilising two high-speed cameras. The flexible composite hydrofoil was manufactured as a carbon/glass-epoxy hybrid structure with a lay-up sequence selected principally to consider spanwise bending deformations with no material-induced bend–twist coupling. Hydrodynamic bend–twist coupling is seen to result in nose-up twist deformations causing frequency modulation from the increase in cavity length. The lock-in phenomenon driven by re-entrant jet shedding observed on the stiff hydrofoil is also evident on the flexible hydrofoil at $0.70\leqslant \unicode[STIX]{x1D70E}\leqslant 0.75$ , but occurs between different modes. Flexibility is observed to accelerate cavitation regime transition with reducing $\unicode[STIX]{x1D70E}$ . This is seen with the rapid growth and influence the shockwave instability has on the forces, deflections and cavitation behaviour on the flexible hydrofoil, suggesting structural behaviour plays a significant role in modifying cavity physics. The reduced stiffness causes secondary lock-in of the flexible hydrofoil’s one-quarter sub-harmonic, $f_{n}/4$ , at $\unicode[STIX]{x1D70E}$ = 0.4. This leads to the most severe deflections observed in the conditions tested along with a shift in phase between normal force and tip deflection.

Fluid-structure Interaction Simulation of Three-Dimensional Flexible Hydrofoil in Water Tunnel

Multiphase Flow Simulation of Water Entry of a Structure with Complex Geometry Using a Three-Dimensional Parallel Compressible Model

High-fidelity Simulation of Regular Waves Based on Multi-Moment Finite Volume Formulation and THINC Method

Simulations of Interaction Between Flow and a Thin Elastic Beam Using Cip-Based Model with Adaptive Mesh

Fluid-structure coupled analysis of flow-induced vibrations in three dimensional elastic hydrofoils

Fluid structure interaction analysis of a hydrofoil based on fully coupled algorithm

Numerical Simulation of Added Mass Effects on a Hydrofoil in Cavitating Flow Using Acoustic Fluid-Structure Interaction

Numerical simulation of added mass effects on a hydrofoil in cavitating flow using acoustic FSI

A Three-Dimensional Fictitious Domain Method for the Simulation of Fluid-Structure Interactions

Study on Flow-induced Vibration Characteristics of 2-DOF Hydrofoil Based on Fluid-Structure Coupling Method

VFIFE based hybrid simulation for submerged floating tunnel research

Numerical Simulation of Dynamic Characteristics of Hydrofoil Structure under Cavitation Conditions

Cavity dynamics and vibrations of a flexible hydrofoil in the cavitating flow

Numerical simulation of water entry of an inclined cylinder

The influence of fluid–structure interaction on cloud cavitation about a flexible hydrofoil. Part 2.

A sharp MLS penalty immersed finite element method for fluid-structure interaction of highly deformable slender body in turbulent flow

Computational Modeling and Analysis of Flow-induced Vibration of an Elastic Splitter Plate Using a Sharp-interface Immersed Boundary Method

Numerical Investigation Into the Influence on Hydrofoil Vibrations of Water Tunnel Test Section Acoustic Modes

Simulation of fluid − flexible structure interaction

Unsteady Dynamics of Cloud Cavitating Flows around a Hydrofoil

The influence of fluid–structure interaction on cloud cavitation about a rigid and a flexible hydrofoil. Part 3