Abstract:A composite titania thin film consisted of quasi-aligned single-crystalline rutile nanorods embedded in sol-gel-derived anatase aggregates was fabricated and its photoelectrochemical behavior was studied in detail. A monolayer of nearly sing I e-crystal line rutile nanorods was first deposited on metallic Ti substrates through a controlled reaction between Ti and hydrogen peroxide. The gaps among the rutile nanorods were then filled with titania nanoparticles through a sol-gel dip-coating approach, which achieved a composite thin film of single-crystalline rutile nanorods embedded in anatase aggregates, after a subsequent thermal treatment at 723 K. The X-ray diffraction measurement revealed that the composite film with thickness of 180 nm contained anatase and rutile in a nearly 50:50 ratio. The UV-visible diffusive reflectance spectra estimated a band gap of 2.99 eV for the rutile monolayer and a slightly increased value of 3.03 eV for the composite film due to the embedding of the anatase nanoparticles. Photocurrent versus potential diagrams, photocurrent transient curves, and open-circuit potential measurement supported the fact that the anatase nanoparticles possessed better inherent photoelectrochemical properties than rutile. However, electrochemical impedance spectra characterization, together with photocurrent transient curves and open-circuit potential measurement, suggests that the single-crystalline rutile nanorods exhibited a higher electron-transfer rate. The combination of the two components in such an appropriate way enhanced significantly the charge separation effect arising from the anatase/rutile couple, which hence combined efficiently the "mixed crystal effect" and the "mixed morphological effect". A steady-state photocurrent more than double the simple sum of those generated by the two components alone was detected for the current composite film, which can be attributed to the single-crystalline rutile nanorods that provide channels for rapid electron transfer to the conductive Ti substrates under an applied bias potential. As a result, this study concludes that the present nanostructure magnified significantly the well-established mixed crystal effect, that is, an enhanced charge separation arising from a mixture of anatase and rutile.

Pt/Y 2 O 3 :Eu 3+ Composite Nanotubes: Enhanced Photoluminescence and Application in Dye-Sensitized Solar Cells

Enhanced photovoltaic performance of dye-sensitized solar cells using a new photoelectrode material: upconversion YbF3-Ho/TiO2 nanoheterostructures

Synthesis of g-C3N4/Bi2O3/TiO2 composite nanotubes: enhanced activity under visible light irradiation and improved photoelectrochemical activity

23327Enhanced photoelectric conversion efficiency of dye-sensitized solar cells by the incorporation of flower-like Bi2S3:Eu3+ sub-microspheres

Synthesis of Co3O4/Ag/TiO2 Nanotubes Arrays Via Photo-Deposition of Ag and Modification of Co3O4 (311) for Enhancement of Visible-Light Photoelectrochemical Performance

Enhanced photoelectric conversion efficiency of dye-sensitized solar cells by the synergetic effect of NaYF4:Er3+/Yb3+ and g-C3N4

Enhanced Photoelectric Conversion Efficiency of Dye-Sensitized Solar Cells by the Synergetic Effect of NaYF 4 :Er 3+ /yb 3+ and G-C 3 N 4

Enhanced Photoelectrochemical Response of a Composite Titania Thin Film with Single-Crystalline Rutile Nanorods Embedded in Anatase Aggregates

A Nanocomposite of Carbon Quantum Dots and Tio2 Nanotube Arrays: Enhancing Photoelectrochemical and Photocatalytic Properties

Luminescent Material with Functionalized Graphitic Carbon Nitride As a Photovoltaic Booster in DSSCs: Enhanced Charge Separation and Transfer

Porous, platinum nanoparticle-adsorbed carbon nanotube yarns for efficient fiber solar cells.

Enhanced Efficiency of Dye Sensitized Solar Cell Using Eu Doped TiO2-ZrO2 Nanocomposite

Enhanced Near-Infrared to Visible Upconversion Nanoparticles of Ho³⁺-Yb³⁺-F⁻ Tri-Doped TiO₂ and Its Application in Dye-Sensitized Solar Cells with 37% Improvement in Power Conversion Efficiency.

Carbon Nanotubes Coated with Y and Eu Oxide Nano-Particles and Their Luminescent Properties

Hybrid TiO2–SnO2 Nanotube Arrays for Dye-Sensitized Solar Cells

Enhanced Conversion Efficiency of Dye-Sensitized Solar Cells Using Sm2O3–modified TiO2 Nanotubes

Enhanced Visible-Light Photoelectrochemical Conversion on TiO2 Nanotubes with Bi2S3 Quantum Dots Obtained by in Situ Electrochemical Method

Inorganic Nanotube/Organic Nanoparticle Hybrids for Enhanced Photoelectrochemical Properties

Enhanced Electron Collection in Photoanode Based on Ultrafine TiO2 Nanotubes by a Rapid Anodization Process

Aggregated TiO 2 -Based Nanotubes for Dye Sensitized Solar Cells

Enhanced Photoelectrochemical Performance by Synthesizing CdS Decorated Reduced TiO2nanotube Arrays