Abstract:The thermophysical properties, including composition, thermodynamic properties, transport coefficients and net emission coefficients, of thermal plasmas formed from pure iso-C4 perfluoronitrile C4F7N and C4F7N-CO2 mixtures are calculated for temperatures from 300 to 30 000 K and pressures from 0.1 to 20 atm. These gases have received much attention as alternatives to SF6 for use in circuit breakers, due to the low global warming potential and good dielectric properties of C4F7N. Since the parameters of the large molecules formed in the dissociation of C4F7N are unavailable, the partition function and enthalpy of formation were calculated using computational chemistry methods. From the equilibrium composition calculations, it was found that when C4F7N is mixed with CO2, CO2 can capture C atoms from C4F7N, producing CO, since the system consisting of small molecules such as CF4 and CO has lower energy at room temperature. This is in agreement with previous experimental results, which show that CO dominates the decomposition products of C4F7N-CO2 mixtures; it could limit the repeated breaking performance of C4F7N. From the point of view of chemical stability, the mixing ratio of CO2 should therefore be chosen carefully. Through comparison with common arc quenching gases (including SF6, CF3I and C5F10O), it is found that for the temperature range for which electrical conductivity remains low, pure C4F7N has similar rho C-p (product of mass density and specific heat) properties to SF6, and higher radiative emission coefficient, properties that are correlated with good arc extinguishing capability. For C4F7N-CO2 mixtures, the electrical conductivity is very close to that of SF6 while the rho C-p peak at 7000 K caused by decomposition of CO implies inferior interruption capability to that of SF6. The calculated properties will be useful in arc simulations.

Effects of Copper Vapour on Thermophysical Properties of CO 2 -N 2 Plasma

Effect of Cu Vapour on the Physical Property Parameters of CO2 Arc Plasma

Influence of Al, Fe or Cu Vapour on Thermophysical Properties of CO 2 Plasmas

Influence of Copper Contamination on Equilibrium Compositions, Thermodynamic Properties, Transport Coefficients, and Combined Diffusion Coefficients of High-Temperature SF6 Gas

Thermodynamic Properties And Transport Coefficients Of Co2-Cu Thermal Plasmas

Effect of Copper Vapor on Radiation Properties of C4F7N Gas Mixtures

Influence of Copper Vapor on Low-Voltage Circuit Breaker Arcs During Stationary and Moving States

Thermodynamic Properties and Transport Coefficients of CO–Cu Thermal Plasmas

Thermodynamic Properties and Transport Coefficients of C4F7N/CO2 Thermal Plasma As an Alternative to SF6

Study of the Influence of Cu Vapour on Air Arc Characteristics

Two-temperature Thermodynamic and Transport Properties of SF6–Cu Plasmas

Thermodynamic Properties and Transport Coefficients of High-Temperature CO2thermal Plasmas Mixed with C2F4

Influence of Metallic Vapours on Thermodynamic and Transport Properties of Two-Temperature Air Plasma

Thermophysical Properties of SF6-Cu Mixtures at Temperatures of 300–30,000 K and Pressures of 0.01–1.0 MPa: Part 2. Collision Integrals and Transport Coefficients

Properties of C4F7N–CO2 thermal plasmas: thermodynamic properties, transport coefficients and emission coefficients

Calculation of Thermodynamic Properties and Transport Coefficients of SF6-PTFE-Cu Mixtures

Calculation of Thermodynamic Properties and Transport Coefficients of CO2–O2–Cu Mixtures

Prediction of the Critical Reduced Electric Field Strength for Carbon Dioxide and Its Mixtures with Copper Vapor from Boltzmann Analysis for A Gas Temperature Range of 300 K to 4000 K at 0.4 Mpa

Calculation of Combined Diffusion Coefficients in N2-Ar-Cu Mixtures

Effects of Buffer Gases on Plasma Properties and Arc Decaying Characteristics of C 4 F 7 N–N 2 and C 4 F 7 N–CO 2 Arc Plasmas

Electrode Evaporation Effects on Air Arc Behavior