Design and implementation of the integrated microfluidic driving system based on DSP

Xiaoyu WANG,Xingyang LIU,Jian WU,Xiang QIAN

DOI: https://doi.org/10.3969/j.issn.2095-2783.2015.20.019

2015-01-01

Abstract:Microfluidic chip driving microfluid control system is designed,based on TMS320F28335 DSP.LabVIEW application is applied to send the signals to DSP to generate corresponding ePWM waveform,which is used to derive solenoid driver circuit.So-lenoid driver circuit is used to control gas line on microfluidic chip,sequential denection of elastic membranes is achieved by peri-odic pressure waveforms traveling through pneumatic channel,and eventually to control fluid flow inside the flow channel.The classic six-phase control is simplified to three-phase control,by introducing the Unger’s Pneumatic micropump.On the basis of the frequency as a pneumatic actuator control fluid flow in microfluidic channels,researched the gas line turn-on duty cycle as a parameter that may affect the microfluidic flow rate.Microfluidic conduit which width is 500 μm can be achieved 0-4 μL/min ad-justable flow rate under 8 Hz;at the same time when the driving duty ratio of 40%-65%,preferably at a platform obtained better flow velocity.