Abstract:Streamer properties such as their velocity, diameter, intensity and density, can be obtained by analysis of temporal and spatial resolved ICCD imaging. In this paper, experimental results on streamer generation and propagation as a function of several high-voltage pulse and reactor parameters are described. Experiments were performed on a large scale wire-plate reactor in ambient air. The set-up allows for independent variation of the parameters over wide ranges. The minimum gate time of the ICCD camera is 5 ns, allowing for a high temporal resolution. The camera can be triggered with a precision of 1 ns. Both negative and positive polarity pulses are investigated. The most important conclusions are as follows. (1) The streamer velocity ((0.5-2.5) x 10(6) ms(-1)) increases if the applied electric field and/or the voltage rise rate is increased. (2) The same is true regarding the velocity ((0.2-1.2) x 10(5) ms(-1)) with which the streamer diameter (0.7-3.0 mm) increases during propagation. ( 3) Typical properties (velocity, diameter, etc) of negative and positive polarity streamers vary less than 25%, especially when the applied electric field is high. (4) As long as the dc bias voltage is below the dc corona onset value it does not have a separate effect on the visual streamer properties. Only the total voltage (peak voltage + dc) is of importance. (5) A simple model was used to determine the electric field in the secondary streamer channel. It was found that in the light emitting part of the secondary streamer the electric field is approximately 21.5 kV cm(-1). In the remainder (dark part) of the channel the electric field is around 6.5 kV cm(-1). This paper shows mainly experimental findings. Not all observed relations and phenomena could be explained. This is partly caused by the fact that current theoretical and numerical models are not yet able to describe the experimental situation as used during this study.

Characteristics of Streamer Propagation along Insulation Surface: Quantitative Influence of Permittivity and Surface Properties

Quantitative Effects of Dielectric Constant and Surface Properties on Streamer Propagation Along the Insulation Surface

Characteristics of Streamer Discharge Along Insulation Surface in Low-temperature Environment

Characteristics of Streamer Propagation along Insulation Surface: Influence of Shed Configuration

Characteristics of Streamer Propagation along the Insulation Surface: Influence of Air Pressure and Humidity

Overview of Streamer Propagation Along Insulation Surfaces in the Uniform Field

Analysis of Streamer Properties in Air As Function of Pulse and Reactor Parameters by Iccd Photography

Surface Streamer Patterns Induced by a Strong Vertical Electric Field under Impulse Voltages

Characteristics Of Streamer Discharge Development Between The Dielectric-Coated Sphere-Plane Electrodes In Water

Streamer Propagation along the Insulator with the Different Curved Profiles of the Shed.

A computational study of positive streamers interacting with dielectrics

A Study on Streamer Discharge Characteristics along Contamination Insulator Surface

Influence of Contaminated Location on Streamer Discharge

In Situ Observation of the Nanosecond Two-Dimensional Surface Charge Evolution During the Process of a Surface Discharge Streamer

Influence of Pollution on Surface Streamer Discharge

Evolution of positive streamers in air over non-planar dielectrics: Experiments and simulations

Experimental and Numerical Study on Surface Streamer Evolution in SF6/N2 Gas Mixtures

Positive and negative streamer propagation in volume dielectric barrier discharges with planar and porous electrodes

The effect of conductivity on streamer initiation and propagation between dielectric-coated sphere-plate electrodes in water

Experimental Research on Influences of Air Pressure and Humidity on Characteristics of Streamer Propagation along Insulation Surfaces

Study on the Discharge Characteristics along the Surface of Insulating Media in the Low Air Pressure and Strong Airflow Environment