Abstract:Lithium–sulfur (Li–S) batteries are severely hindered by the low sulfur utilization and short cycling life, especially at high rates. One of the effective solutions to address these problems is to improve the sulfiphilicity of lithium polysulfides (LiPSs) and the lithiophilicity of the lithium anode. However, it is a great challenge to simultaneously optimize both aspects. Herein, by incorporating the merits of strong absorbability and high conductivity of SnS with good catalytic capability of ZnS, a ZnS-SnS heterojunction coated with a polydopamine-derived N-doped carbon shell (denoted as ) with uniform cubic morphology was obtained and compared with the ZnS-SnS2@NC heterostructure and its single-component counterparts ( and SnS2@NC). Theoretical calculations, ex situ XANES, and in situ Raman spectrum were utilized to elucidate rapid anchoring-diffusion-transformation of LiPSs, inhibition of the shuttling effect, and improvement of the sulfur electrochemistry of bimetal ZnS-SnS heterostructure at the molecular level. When applied as a modification layer coated on the separator, the cell with optimized lithiophilicity and sulfiphilicity enables desirable sulfur electrochemistry, including high reversibility of 1149 mAh g–1 for 300 cycles at 0.2 C, high rate performance of 661 mAh g–1 at 10 C, and long cycle life with a low fading rate of 0.0126% each cycle after 2000 cycles at 4 C. Furthermore, a favorable areal capacity of 8.27 mAh cm–2 is maintained under high sulfur mass loading of 10.3 mg cm–2. This work furnishes a feasible scheme to the rational design of bimetal sulfides heterostructures and boosts the development of other electrochemical applications.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsnano.1c00270?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsnano.1c00270</a>.Additional experimental sections (materials synthesis, characterizations, and DFT calculations); SEM, TEM, XRD, TG, XPS, BET, and XANES characterizations of the samples; CV curves; discharge–charge profiles and cycle performance of various electrodes; in situ Raman tests; optimized geometries of LiPSs; Tables S1–S6: Li+ diffusion rates, EIS fitting, and comparisons of electrochemical performance (<a class="ext-link" href="/doi/suppl/10.1021/acsnano.1c00270/suppl_file/nn1c00270_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Electrochemical impedance spectroscopy study of sulfur reduction pathways using a flexible, free-standing and high-sulfur-loading film

Enhanced catalysis LiS<sub>3</sub> of radical-to-polysulfide interconversion <i>via</i> increased sulfur vacancies in lithium-sulfur batteries

Insight into sulfur reactions in Li-S batteries.

Revealing the Sulfur Redox Paths in a Li–S Battery by an In Situ Hyphenated Technique of Electrochemistry and Mass Spectrometry

The formation of crystalline lithium sulfide on electrocatalytic surfaces in lithium–sulfur batteries

Expediting Redox Kinetics of Sulfur Species by Atomic‐scale Electrocatalysts in Lithium–sulfur Batteries

A lithium-sulfur battery with a solution-mediated pathway operating under lean electrolyte conditions

Polysulfide-Mediated Solvation Shell Reorganization for Fast Li+ Transfer Probed by In-Situ Sum Frequency Generation Spectroscopy

ZnS-SnS@NC Heterostructure as Robust Lithiophilicity and Sulfiphilicity Mediator toward High-Rate and Long-Life Lithium–Sulfur Batteries

Catalytic Oxidation of Li 2 S on the Surface of Metal Sulfides for Li−S Batteries

Unveiling the Role of Electric Double-Layer in Sulfur Catalysis for Batteries

Concerted Formation of Reversibly Precipitated Sulfur Species and Its Importance for Lean Electrolyte Lithium-Sulfur Batteries

An Electrocatalytic Model of the Sulfur Reduction Reaction in Lithium–Sulfur Batteries

Manipulating Electrocatalytic Li<sub>2</sub>S Redox via Selective Dual-Defect Engineering for Li-S Batteries

Rational design of bidirectional electrocatalysts and accelerated sulfur redox reactions in lithium-sulfur batteries

Improving Lithium-Sulfur Battery Performance under Lean Electrolyte Through Nanoscale Confinement in Soft Swellable Gels.

Manipulating Redox Kinetics of Sulfur Species Using Mott–Schottky Electrocatalysts for Advanced Lithium–Sulfur Batteries

Engineering single-atom catalysts as multifunctional polysulfide and lithium regulators toward kinetically accelerated and durable lithium-sulfur batteries

Defects-Rich Single Atom Catalyst Enhanced Polysulfide Conversion Kinetics for Upgrading Performance of Li-S Batteries

Initiating a Reversible Aqueous Zn/Sulfur Battery through a “Liquid Film”

Electrochemical investigation of Li-ion diffusion and absorbing polysulfide of hierarchically structured carbon for the quasi-solid lithium-sulfur batteries