Abstract:Anammox process has been widely applied in the wastewater nitrogen removal for its high rate and low cost. However, few researches reported the process potential in treating low-strength nitrogen wastewater. In this study, a sequencing batch reactor (SBR) was taken to explore the feasibility of low-strength nitrogen wastewater treatment by anammox process in theory and practice. The practical operation indicated that the effluent with satisfactory quality (1.90 ± 0.70 mg-TN·L−1) could be achieved, when the SBR was fed with low-strength nitrogen influent (6.20 ± 0.45 mg-NH4+-N·L−1 and 7.96 ± 0.59 mg-NO2--N·L−1). The hydraulic retention time (HRT), nitrogen removal efficiency, nitrogen removal rate (NRR) and hydraulic loading rate of SBR were 5.42 h, 86.5%, 0.054 kg-N·m−3·d−1 and 4.43 m3·m−3·d−1 during the 79-day operation, respectively. The theoretical analysis revealed the potential of anammox SBR. When SBR is stably operated, the maximum NRR would be 0.062 kg-N·m−3·d−1 if the effluent nitrogen was required to be as low as 3 mg·L−1. The NRR value is feasible for engineering. However, considering the lower specific substrates utilization rate in practice, the maximum stable NRR was calibrated and found inefficient afterwards. In order to improve the potential of anammox process, the reactors without back mixing and with periodic bioaugmentation should be taken in priority for the engineering applications. In particular, the bioaugmentation frequency and single addition amount were calculated as 7 d and 0.3 g-VSS·L−1, respectively. The results may provide guidance for the development of high-efficient and stable nitrogen removal process under low-strength condition.

Primary study on the treatment of high strength ammonia-nitrogen industrial wastewater

Comparative Research on the Nitrogen Removal from Wastewater of High Ammonia Concentration Through Nitrosofication and Nitrification Ways

Research on treatment of ammonia nitrogen in electroplating wastewater by sodium hypochlorite and its ORP control mode

Nitrogen Removal Performance of Anammox Process and Toxic Mechanism of Pharmaceutical Wastewater

Deep Purification of Low-Strength Ammonium-Containing Wastewater with ANRE Process

Experimental Research on Removal of Nitrogen and Phosphorus in Enhanced Sequencing Batch Reactor Activated Sludge Process

Performance of ANAMMOX-EGSB Reactor

Combination of High-pressure Aeration System and Activated Anthracite Filter for High Ammonia Nitrogen Removal

Research on the large-scale application of nitrogen removal for the treatment of synthetic ammonia wastewater

Potential of anammox process towards high-efficient nitrogen removal in wastewater treatment: Theoretical analysis and practical case with a SBR

A Reformed SBR Technology Integrated with Two‐step Feeding and Low‐intensity Aeration for Swine Wastewater Treatment

Nitrogen Removal from Sludge Dewatering Effluent Through Anaerobic Ammonia Oxidation Process.

[Start-Up of a Full-Scale System for Short-Cut Nitrification and Anammox in Treatment of Pharmaceutical Wastewater].

Treatment of High Strength Wastewater Containing High Concentrations of Ammonium using SBR Bioreactor

Effect of the Rapid Increase of Salinity on Anoxic-Oxic Biofilm Reactor for Treatment of High-Salt and High-Ammonia-nitrogen Wastewater.

Experimental Study on the Electrochemical Oxidation of Ammonia Wastewater

Research on Aerobic Nitrosation of Domestic Sewage with Low Ammonia Nitrogen

Study on the treatment of high ammonia-nitrogen wastewater by optimizing MAP method using response surface anaIysis

Treatment Technologies of High Concentration Ammonia Nitrogen Wastewater and Their Research and Application Status

Treatment of ammonia‐nitrogen wastewater by the ultrasonic strengthened break point chlorination method

Research on the Dry Acrylon Wastewater Treatment by Single and Two Phase Anaerobic Methods