Effect of Surface Wettability on Nanoparticle Deposition during Pool Boiling on Laser-Textured Copper Surfaces

Jure Berce,Armin Hadžić,Matic Može,Klara Arhar,Henrik Gjerkeš,Matevž Zupančič,Iztok Golobič

DOI: https://doi.org/10.3390/nano14030311

IF: 5.3

2024-02-04

Nanomaterials

Abstract:Prior studies have evidenced the potential for enhancing boiling heat transfer through modifications of surface or fluid properties. The deployment of nanofluids in pool boiling systems is challenging due to the deposition of nanoparticles on structured surfaces, which may result in performance deterioration. This study addresses the use of TiO2–water nanofluids (mass concentrations of 0.001 wt.% and 0.1 wt.%) in pool boiling heat transfer and concurrent mitigation of nanoparticle deposition on superhydrophobic laser-textured copper surfaces. Samples, modified through nanosecond laser texturing, were subjected to boiling in an as-prepared superhydrophilic (SHPI) state and in a superhydrophobic state (SHPO) following hydrophobization with a self-assembled monolayer of fluorinated silane. The boiling performance assessment involved five consecutive boiling curve runs under saturated conditions at atmospheric pressure. Results on superhydrophilic surfaces reveal that the use of nanofluids always led to a deterioration of the heat transfer coefficient (up to 90%) compared to pure water due to high nanoparticle deposition. The latter was largely mitigated on superhydrophobic surfaces, yet their performance was still inferior to that of the same surface in water. On the other hand, CHF values of 1209 kW m−2 and 1462 kW m−2 were recorded at 0.1 wt.% concentration on both superhydrophobic and superhydrophilic surfaces, respectively, representing a slight enhancement of 16% and 27% compared to the results obtained on their counterparts investigated in water.

materials science, multidisciplinary,physics, applied,nanoscience & nanotechnology,chemistry

What problem does this paper attempt to address?

The main problem that this paper attempts to solve is to improve the heat transfer performance of nanofluids in the pool boiling process through the regulation of surface wettability and, at the same time, reduce the deposition of nanoparticles on the structured surface. Specifically, the researchers used TiO₂ - water nanofluids (with mass concentrations of 0.001 wt.% and 0.1 wt.%) and carried out pool boiling experiments on laser - textured copper surfaces, which were adjusted to super - hydrophilic (SHPI) and super - hydrophobic (SHPO) states. The study aims to evaluate the influence of different wettabilities on nanoparticle deposition and the potential enhancement effects on the heat transfer coefficient (HTC) and critical heat flux (CHF).

The paper mentions that although in some studies, the use of nanofluids has been shown to be able to improve the boiling heat transfer performance, the deposition of nanoparticles on the heating surface will lead to additional thermal resistance, thereby reducing the heat transfer efficiency. Therefore, by adjusting the wettability of the surface, especially using a super - hydrophobic surface, the deposition of nanoparticles can be reduced, thereby improving the heat transfer performance. However, even on the super - hydrophobic surface, the deposition of nanoparticles will still have a negative impact on heat transfer, although this impact is much smaller than that on the super - hydrophilic surface.

In addition, the paper also explores how to optimize the wettability of the surface through surface modification techniques (such as laser texturing and self - assembled monolayer coating) to further improve the efficiency of boiling heat transfer. In this way, the researchers hope to find an effective method that can both take advantage of the nanofluids and avoid or mitigate the adverse effects brought by nanoparticle deposition.