Abstract:Abstract The Gas and Downhole Water Sink-Assisted Gravity Drainage (GDWS-AGD) process functions to enhance oil recovery by placing vertical gas injectors at the top of the reservoir combined with a series of horizontal wells located in the lower part of the reservoir for oil and water production. The injected gas accumulates to form or enhance a gas cap, while oil and water drain by gravity towards the base of the reservoir due to their heavier densities. To further enhance oil recovery, and to overcome the economic limitations of using vertical gas injectors, multi-completion production wells can also be used for gas injection through their annulus sections. This novel configuration thereby achieves Multi Completion-Gas and Downhole Water Sink-Assisted Gravity Drainage (MC-GDWS-AGD). The feasibility of MC-GDWS-AGD is investigated in this study by numerical simulation of the heterogeneous PUNQ-S3 reservoir, which is surrounded and supported by strong aquifers. The MC-GDWS-AGD process aims to minimize water cut in oil production wells from offshore reservoirs with bottom water drives and strong water coning tendencies. In the combined technologies, the gas is injected through the annulus of 7-inch production casings at the top of the reservoir. Then the same casing is dually completed for two 2-3/8 inch horizontal tubing strings: one above the oil-water contact for oil production, and one beneath that contact to function as the water sink. The two completions are hydraulically isolated within the wellbore by a packer. The lower (water sink) completion employs a submersible pump and water-drainage perforations. The submersible pump drains the accumulation of water from around the well. By doing so it prevents the water from breaking through into the oil column and adversely affecting production through the horizontal oil-producing perforations. The heterogeneous multilayered PUNQ-S3 reservoir, which is surrounded by infinite aquifers, was considered to simulate this process. The MC-GDWS-AGD process simulation is designed to evaluate oil flow rate, cumulative oil production, and water cut in oil production wells. The simulation compares the performance of MC-GDWS-AGD with the GAGD and GDWS-AGD completion configurations. The simulation results reveal similar performance for the MC-GDWS-AGD and GDWS-AGD configurations, for all the parameters considered. The GDWS-AGD method slightly outperforms the MC-GDWS-AGD method by achieving a small increase in cumulative oil production from 1.8x 106 m3 for the GAGD method to 1.83x 106 m3. Both methods exceeded primary recovery in terms of cumulative oil production. Water cut decreased from 74% in the GAGD method to 63% in the MC-GDWS-AGD process. The oil recovery factor achieved by the MC-GDWS-AGD process increased by about 8% compared to that achieved by the GAGD method. The value of the MC-GDWS-AGD process is associated with its effectiveness to improve oil recovery by reducing the water coning, water cut, and improving gas injectivity, and at the same time reducing well costs. This new process allows for gas injection, oil, and water production to be conducted through a single multi-completed wellbore. This configuration also leads to multiple additional economic benefits, some of which are associated with the reduction of operational surface facilities in offshore oil fields.

Experimental Research of Simultaneous Water and Gas Injection Technology into Injection Wells using Mixing Devices

Perspectives of application of simultaneous water and gas injection for utilizing associated petroleum gas and enhancing oil recovery in the Arctic fields

Use of Self-Generating Foam Gel Composition with Subsequent Injection of Hydrogel to Limit Gas Inflow in Horizontal Wells of Vostochno-Messoyakhskoye Field

Diagnostics of gas-dynamic connection between gas caps and their influence on the product composition of the North Caspian production wells as per tracer tests

Study of the efficiency of trapped gas displacement by non-hydrocarbon gases from water-flooded gas condensate reservoirs

Development of a pump-ejector system for SWAG injection into reservoir using associated petroleum gas from the annulus space of production wells

Integration of advanced technologies to improve the efficiency of gas condensate field development

Selection of EOR Technology in Ultra-Low-Permeability Reservoirs of the Achimov Deposits of the Priobsky Field

Well drilling with combined pressure control

Experimental study of variable density compound water control based on continuous packer——A case study of deep-water HP/HT LS25 gas field in the South China Sea

Experimental and Numerical Simulation Studies on the Synergistic Design of Gas Injection and Extraction Reservoirs of Condensate Gas Reservoir-Based Underground Gas Storage

Development of A Multi-Completion-Gas and Downhole Water Sink-Assisted Gravity Drainage MC-GDWS-AGD Process to Enhance Oil Recovery and Reduce Water Cresting in Reservoirs With Strong Water Aquifers

A novel method of bidirectional displacement with artificial nitrogen gas cap and edge water for enhanced oil recovery: Experimental and simulation approaches

Technique for calculating technological parameters of non-Newtonian liquids injection into oil well during workover

An Intelligent Artificial Lift Technology and its Trial in Middle East: Integration of Remote Wireless Control and Artificial Automation for Zonal Water Injection

SUBSTANTIATION OF METHOD FOR LEVELING INJECTIVITY PROFILE UNDER CONDITIONS OF CARBONATE RESERVOIRS OF FIELD NAMED AFTER R. TREBSA

First Multistage Hydraulic Fracturing in Russian Offshore: Integrated Approach to Completion and Stimulation of Apt Deposits of V.Filanovsky Field

EXPERIENCE IN USING PRE-CROSSLINKED POLYMER SYSTEMS FOR ENHANCED OIL RECOVERY IN CARBONATE RESERVOIRS

Design of Surface Facilities for a High-Pressure Miscible Gas Injection Pilot Scheme

INTELLIGENT NATURAL DUMP FLOODING WELL - CASE STUDY FROM THE AREA OF THE WESTERN PERSIAN/ARABIAN GULF AND POSSIBLE APPLICATION IN THE CROATIAN MATURE OIL FIELD BENIČANCI

Successful Development of Residual Gas Condensate Reservoir using First ESP in Deep High Pressure and Temperature in Rich Gas Condensate Wells