Abstract:The IEEE 802.11 wireless local-area network (WLAN) has been deployed around the globe as a major Internet access medium due to its low cost and high flexibility and capacity. Unfortunately, dense wireless networks can suffer from poor performance due to high levels of radio interference resulting from adjoining access points (APs). To address this problem, we studied the AP transmission power optimization method, which selects the maximum or minimum power supplied to each AP so that the average signal-to-interference ratio (SIR) among the concurrently communicating APs is maximized.However, this method requires measurements of receiving signal strength (RSS) under all the possible combinations of powers. It may need intolerable loads and time as the number of APs increases. It also only considers the use of channel bonding (CB), although non-CB sometimes achieves higher performance under high levels of interference. In this paper, we present an AP interface setup optimization method using the throughput estimation model for concurrently communicating APs. The proposed method selects CB or non-CB in addition to the maximum or minimum power for each AP. This model approach avoids expensive costs of RSS measurements under a number of combinations. To estimate the RSS at an AP from another AP or a host, the model needs the distance and the obstacles between them, such as walls. Then, by calculating the estimated RSS with the model and calculating the SIR from them, the AP interface setups for a lot of APs in a large-scale wireless network can be optimized on a computer in a very short time. For evaluation, we conducted extensive experiments using Raspberry Pi for APs and Linux PCs for hosts under 12 network topologies in three buildings at Okayama University, Japan, and Jatiya Kabi Kazi Nazrul Islam University, Bangladesh. The results confirm that the proposed method selects the best AP interface setup with the highest total throughput in any topology.

Optimizing AP association in wireless mesh network with multipath TCP

A Dynamic Packet Scheduling Method for Multipath TCP in Heterogeneous Wireless Networks

Learning-driven Cost-Efficient Multi-access Mobile Edge Computing Via NOMA-SWIPT Transmission

MPCC: Optimal Congestion Control for Multipath Routing in Ad Hoc Networks

Load-balanced AP Association in Multi-Hop Wireless Mesh Networks

Can MPTCP Increase System Efficiency and Fairness in 802.11 Multirate WLAN Environment?

A Multi-AP Architecture for High-Density WLANs: Protocol Design and Experimental Evaluation

User-Access Point Association for High Density MIMO Wireless LANs

Joint optimization of power control, channel assignment and scheduling in wireless mesh network

An Interface Setup Optimization Method Using a Throughput Estimation Model for Concurrently Communicating Access Points in a Wireless Local Area Network

Improving Access Point Association Protocols Through Channel Utilization and Adaptive Probing

Throughput Optimization Via Association Control in Wireless LANs.

Joint Resource Allocation for Maximizing Energy Efficiency in MmWave-Based Wireless-Powered Communication Networks

Improved AP Association Management Using Machine Learning

AP Association in 802.11n WLANs with Heterogeneous Clients

Path Diversified Multi-Qos Optimization in Multi-Channel Wireless Mesh Networks

Distributed Physical Carrier Sensing Adaptation Scheme in Cooperative Map Wlan

Designing a Practical Access Point Association Protocol

SmartAssoc: Decentralized Access Point Selection Algorithm to Improve Throughput

ISAC‐oriented access point placement in cell‐free mMIMO systems

Survey of MPTCP-Based Multipath Transmission Optimization