Abstract:In this work, effective methods for monitoring friction and wear of journal bearings integrated in future UltraFan® jet engines containing a gearbox are presented. These methods are based on machine learning algorithms applied to Acoustic Emission (AE) signals. The three friction states: dry (boundary), mixed, and fluid friction of journal bearings are classified by pre-processing the AE signals with windowing and high-pass filtering, extracting separation effective features from time, frequency, and time-frequency domain using continuous wavelet transform (CWT) and a Support Vector Machine (SVM) as the classifier. Furthermore, it is shown that journal bearing friction classification is not only possible under variable rotational speed and load, but also under different oil viscosities generated by varying oil inlet temperatures. A method used to identify the location of occurring mixed friction events over the journal bearing circumference is shown in this paper. The time-based AE signal is fused with the phase shift information of an incremental encoder to achieve an AE signal based on the angle domain. The possibility of monitoring the run-in wear of journal bearings is investigated by using the extracted separation effective AE features. Validation was done by tactile roughness measurements of the surface. There is an obvious AE feature change visible with increasing run-in wear. Furthermore, these investigations show also the opportunity to determine the friction intensity. Long-term wear investigations were done by carrying out long-term wear tests under constant rotational speeds, loads, and oil inlet temperatures. Roughness and roundness measurements were done in order to calculate the wear volume for validation. The integrated AE Root Mean Square (RMS) shows a good correlation with the journal bearing wear volume.

Characterisation of Acoustic Emissions for the Frictional Effect in Engines Using Wavelets Based Multi-Resolution Analysis

Acoustic Analysis of Particle–Wall Interaction and Detection of Particle Mass Flow Rate in Vertical Pneumatic Conveying

The Investigation into the Tribological Impact of Alternative Fuels on Engines Based on Acoustic Emission

Analysis of the Dynamic Friction of a Gas Face Seal Based on Acoustic Emissions

A Time-Frequency Based Approach for Acoustic Emission Assessment of Sliding Wear

Friction and Wear Monitoring Methods for Journal Bearings of Geared Turbofans Based on Acoustic Emission Signals and Machine Learning

A Study of Sliding Friction Using an Acoustic Emission and Wavelet-Based Energy Approach

Study on the Friction Behavior and Abnormal Conditions of Non-contact Mechanical Seal Based on Acoustic Emission

Application of Acoustic Emission Technique to Monitor the Viscosity of Single Grade Diesel Engine Lubricant Oil.

Acoustic Emission and Its Relationship with Friction and Wear for Sliding Contact

Study on Stick–Slip Friction of Reciprocating O-Ring Seals Using Acoustic Emission Techniques

Experimental Investigation on Friction Characteristics of Ultrasonic Motor

Identification and Evaluation of Diesel Engine Noise Source Based on Acoustic Intensity

The Effects of Ultra-Low Viscosity Engine Oil on Mechanical Efficiency and Fuel Economy

Analysis of friction in surface textured components of reciprocating mechanism

Modelling Acoustic Emissions Induced by Dynamic Fluid-Asperity Shearing in Hydrodynamic Lubrication Regime

Application Of Acoustic Emission Technique In Diagnostics Of Early Rubbing Fault

Online measurement of piston-assembly friction with wireless IMEP method under fired conditions and comparison with numerical analysis

Combined experimental and simulative approach for friction loss optimization of DLC coated piston rings

A Bi-Gaussian Acoustic Emission Model for Sliding Friction

Molecular Dynamics Investigation on Micro-Friction Behavior of Cylinder Liner-Piston Ring Assembly