Abstract:<p>Cluster well drilling technology is the key to large-scale development of unconventional oil and gas, but it is difficult to measure the distance of adjacent wells accurately by using off-the-shelf tilting tools and algorithms. Therefore, this paper proposes a novel algorithm for accurate ranging of adjacent wells while drilling. Firstly, a double-layer radial medium model, a magnetic field distribution law model and a relative position relationship model were established. Then, by solving the above model, the accumulation discipline of low-frequency current on the casing and the distribution law of the magnetic field around the casing are revealed. The calculation method of the relative position relationship is also obtained. The model is also compared with the experimental data of previous scholars to verify its effectiveness. Finally, the sensitivity analysis of the electric field strength in the radial direction, the current distribution on the casing and the magnetic field strength of the measuring point were carried out. The analysis results show that the electric field strength in the radial direction has obvious jump at the interface between the drilling fluid and the formation; the current on the casing and the distribution of the surrounding magnetic field are affected by the current intensity, the conductivity of the drilling fluid, the distance between the wells, the size of the wellbore, and the relative inclination angle of the well; in addition, in the short-distance measurement process, as the distance from electrode to probe is greater than 60 m, the relative well angle of construction well and production well should be controlled within 3° to avoid collision. The research shows that the algorithm can provide theoretical basis for the high-precision measurement of clusters and infill wells.</p>

High precision magnetic ranging for Steam-Assisted Gravity Drainage system

Geometric Predicted Unscented Kalman Filtering in Rotate Magnetic Ranging

Estimation of geomagnetic components under unknown interferences for drilling tools

Numerical simulation and sensitivity analysis of accurate ranging of adjacent wells while drilling

The Data Processing and the Related Software Development of the Active Magnetic Measuring Instrument

Magnetic Field Estimation in Measurement Dead Domain for Dry Calibration of Electromagnetic Flowmeter

A Long-Term Performance Enhancement Method for FOG-Based Measurement While Drilling

Magnetic Guidance Drilling Technology Field Test

Application of scan fitting magnetic ranging method to the intersection in underground drilling

Enhanced Azimuth Determination in Drilling via Piecewise Polynomial Fitting and Interpolation

Online Compensation of Geomagnetic Measurement Errors While Drilling

An Atomic Gravimeter Dynamic Measurement Method Based on Kalman Filter

Manufacture and Field Test of Rotating Magnetic Ranging Service

Real-Time Joint Filtering of Gravity and Gravity Gradient Data Based on Improved Kalman Filter

Solution to Geomagnetic Systems in Areas with Smooth Magnetic Fields

Vibration Noise Modeling for Measurement While Drilling System Based on FOGs

An Extended Kalman Filter for Magnetic Field SLAM Using Gaussian Process Regression

Overhauser Sensor Array Based 3-D Magnetic Gradiometer for the Detection of Shallow Subsurface Unexploded Ordnance

Attitude and Position Measurement of Bit for Underwater Horizontal Directional Drilling System

Attitude Calculation Method of Drilling Tools Based on Cross-Correlation Extraction and ASRUKF

Envelope Extraction Algorithm for Magnetic Resonance Sounding Signals Based on Adaptive Gaussian Filters