Thermo-structural coupling analysis on L-shape HV-MLI cryogenic pipes
Chen Shuping,Mao Hongwei,Yang Jiahui,Li Jun,Liu Fulu,Zhang Junhui
DOI: https://doi.org/10.3787/j.issn.1000-0976.2017.03.013
2017-01-01
Abstract:High vacuum multilayer insulation (HV-MLI) cryogenic pipes which are used to transport low-temperature media (e.g.LNG) are often in a cryogenic environment with internal fluid pressure,so they will bear complex loads due to the effect of thermal-structural coupling.For investigating the response of each part in an HV-MLI cryogenic pipe under complex loads,the thermal-structural coupling finite element model was established based on a certain L-shape HV-MLI cryogenic pipe of horizontal-vertical trending.Then,the distribution of pipe temperature fields in different operating conditions,and the stresses on inner tubes,outer tubes,thermal bridges,bellows and thermal insulation supports and their variation in different loads were calculated.The following findings were obtained based on the above mentioned analysis.First,thermal insulation supports and thermal bridges are the main parts that affect heat leakage of pipes.In the case of LN2 transportation,for example,the heat leakage at thermal insulation supports and thermal bridges accounts for about 49.07％ and 49.32％ of the total pipe heat leakage,respectively.Second,inner tubes,outer tubes,elbows and thermal bridges are very safe when they are in service since their stresses are relatively small and lower than the material yield limit.Third,the stress on bellows increases with the decrease of the transportation medium temperature and the increase of compensation inner tube length.The bellow in a horizontal section is the most dangerous part of the whole pipe due to its higher stress.And fourth,the internal pressure on inner tubes is the main factor impacting the stress of thermal insulation supports.With the increase of the internal pressure on inner tubes,the stress on thermal insulation supports in horizontal and vertical pipe sections,which is the closest to the elbow,increases significantly,but the stress on thermal insulation supports,which is far away from the elbow,doesn't change greatly.Therefore,it is necessary to increase the thickness of thermal insulation supports close to the elbow and reduce the thickness of thermal insulation supports far away from the elbow in order to guarantee the strength as well as to reduce heat leakage.