A Unified Design Method for Multi-Source Complementary Heating Systems Based on a Transient Simulation

Zhang,Guo,Li,Yu,Hui,Zhong,Liu,Ren,Wang
DOI: https://doi.org/10.3390/electronics13071206
IF: 2.9
2024-03-26
Electronics
Abstract:Combining various sources to create a complementary system plays a key role in utilizing clean energy sources economically and mitigating air pollution during the heating season in Northern China. However, there is a lack of unified and reasonable design methods for such systems, resulting in the excessive capacity of equipment and the waste of energy. In this work, a unified design method is proposed to solve this problem. A generalized structure and its mathematical model are firstly established, enabling transient simulations on the TRNSYS platform. Then, a preliminary screening criterion for the system composition a general operation strategy is proposed. Finally, the system configuration is optimized by using the genetic algorithm. The method is successfully applied in a demonstration project in China. The results show that the coupling system consisting of a biomass boiler (384 kW), an air-source heat pump (430 kW) and a ground-source heat pump (369 kW) is the most economical, and the annual cost is 26.7% lower than that of a single-equipment system. Additionally, the sensitive factors that strongly affect the optimization results are explored. The establishment of the generalized structure and its mathematical model enables the quick calculation and convenient comparison of various schemes, and simplifies the complicated optimization problem of the capacity optimization of each piece of equipment. The proposed design method can reduce the annual cost to a minimum value, and thus it provides a theoretical basis for the large-scale application of clean energy sources for heating.
engineering, electrical & electronic,computer science, information systems,physics, applied
What problem does this paper attempt to address?
The problem that this paper attempts to solve is the lack of a unified and reasonable design method in the clean heating system design in northern China, which leads to excessive equipment capacity and energy waste. Specifically, the paper proposes a unified design method for multi - source complementary heating systems based on transient simulation, aiming to optimize the system composition, operation strategy and the capacity of each device, so as to reduce the annual cost and provide a theoretical basis for large - scale application of clean energy for heating. By establishing a general structure and its mathematical model, the paper realizes the transient simulation on the TRNSYS platform, proposes the preliminary screening criteria for system composition and the general operation strategy, and finally uses the genetic algorithm to optimize the system configuration. The research shows that the coupling system composed of a biomass boiler (384 kW), an air - source heat pump (430 kW) and a ground - source heat pump (369 kW) is the most economical, and its annual cost is 26.7% lower than that of a single - device system. In addition, the sensitive factors that have a great influence on the optimization results are also discussed. In short, the paper aims to solve the existing problems in the current clean heating system design by proposing a new design method, thereby promoting the wide application of clean energy in the heating field.