Abstract:Splitter plates have been recognized as useful passive devices to reduce drag, mitigate flow-induced vibration, and enhance heat transfer efficiency of a circular cylinder. However, undesired torsional flow-induced vibrations due to splitter plate attachment require further investigation. This paper numerically studies the flow-induced torsional vibrations of an elastically mounted circular cylinder with an attached splitter plate in laminar flow with a Reynolds number of 100. A finite volume formulation is utilized to solve the incompressible two-dimensional fluid governing equations. Torsional vortex-induced vibrations (VIVs) are observed at lower reduced flow velocities, while a symmetry-breaking bifurcation occurs as the reduced flow velocity increases, after which the cylinder-plate assembly vibrates around a nonzero equilibrium angle. The numerical results show that the synchronization range of VIV extends, the peak VIV amplitude increases, and the critical reduced flow velocity for the bifurcation decreases with decreasing the moment of inertia. The symmetry-breaking bifurcation is due to a combined effect of the structural restoring moment and the flow-induced moment. The critical reduced velocity of the bifurcation and the nonzero equilibrium angle at any reduced velocity can be calculated based on the mean moment coefficients of the cylinder-plate assembly. The flow-induced moment is mainly induced by the pressure difference between the splitter plate's upper and lower surfaces. The phase difference between the torsional moment and displacement is 0° at lower reduced velocities, while the phase difference jumps to 180° at a reduced velocity of approximately 6.5. The mean drag coefficient of the vibrating cylinder-plate assembly is lower than the mean drag coefficient of a stationary circular cylinder but often higher than that of a stationary cylinder-plate assembly. The dominant frequency of the drag force is twice the vibration frequency before the symmetry-breaking bifurcation, while the dominant frequency becomes consistent with the vibration frequency after the bifurcation. The typical 2S mode of vortex shedding is identified for all considered moments of inertia and reduced flow velocities. However, the timing of a non-shedding vortex changes at the critical flow velocities for the phase jump and symmetry-breaking bifurcation. The observed torsional vibrations suggest that circular cylinders with splitter plate attachments may be competitive candidates for VIV-based energy harvesting, while they may not be good choices for heat exchangers.

Effects of splitter plate and mass ratio on flow-induced vibration and heat transfer characteristics of a circular cylinder in turbulent flow: A numerical study

Torsional Vibration of a Circular Cylinder with an Attached Splitter Plate in Laminar Flow

Numerical Study On Flow Over A Confined Oscillating Cylinder With A Splitter Plate

Numerical Investigation of Flow-Induced Vibration for Cylinder-Plate Assembly at low Reynolds Number

Effects of Mass and Damping Ratios on the Flow-Induced Vibration of Two Staggered Circular Cylinders

Effect of Splitter Plate on Vortex-Induced Vibration of Circular Cylinder at High Reynolds Number

Effects of Flow-Induced Vibration on Forced Convection Heat Transfer from Two Tandem Circular Cylinders in Laminar Flow

Poiseuille Flow-Induced Vibrations of Two Cylinders in Tandem

Heat Transfer and Vibration Response of a Stationary Cylinder and an Elastic Cylinder under Mutual Interference

Oscillation Control and Drag Reduction for a Low Mass Ratio Cylinder with Double Splitter Plates

The Roles of Rigid Splitter Plates in Flow-Induced Vibration of a Circular Cylinder

Effects of a detached splitter on the vortex-induced vibration of a 5:1 rectangular cylinder

VORTEX-INDUCED VIBRATION CHARACTERISTICS AND HEAT TRANSFER MECHANISM OF AN OSCILLATING PLATE ATTACHED TO A CYLINDER IN A CONSTANT-TEMPERATURE CHANNEL

Transition of FIV for a circular cylinder with splitter plates

Numerical Investigation of Fluid Flow Past a Square Cylinder Using Upstream, Downstream and Dual Splitter Plates

Pressure Distribution, Fluctuating Forces and Vortex Shedding Behavior of Circular Cylinder with Rotatable Splitter Plates

Effect of Inclination Angle of Splitter Plate on Flow over A Circular Cylinder

Experimental study on the flow-induced vibrations of a circular cylinder with a rear flexibly hinged splitter plate

Study on the Numerical Simulation of Cylinder Vortex-Induced Vibration Controlled by Separating Plate

Numerical investigation of vortex induced vibration effects on the heat transfer for various aspect ratios ellipse cylinder

The Suppression of Flow-Induced Vibrations for a Single and Two Tandem-Arrangement Cylinders Using Three Splitter Plates