Abstract:Two fluorescent high‐performance polymers based on dicyanoarylamine luminogens were readily synthesized via polycondensation. Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive in both solution and solid film states, thereby demonstrating the aggregation‐induced fluorescence changes. Introduction Fluorescent high‐performance polymers have been extensively used in designing optoelectronic devices due to their low cost, excellent thermal stability, high mechanical strength, low flammability, good chemical and radiation resistance, and good electronic properties. While conventional organic luminophores fluoresce strongly in dilute solutions, they suffer from undesirable aggregation‐caused quenching in concentrated solutions and in the solid state due to extensive π‐π stacking interactions and formation of delocalized excitons or excimers. This phenomenon leads to non‐radiative decay thus, decreased fluorescence emission of the material in the solid film state, which significantly limits their real‐world application as solid light‐emitting materials. Objectives To develop new high‐performance polymers with high photo luminescent efficiency, good processability, film‐forming properties, which could potentially be used in the fabrication of optoelectronic devices. Methods The preparation of the polyimide DiCN‐PI was carried out by a one‐step, high‐temperature solution imidization method. In this procedure, 1,2,4,5‐cyclohexanetetracarboxylic dianhydride and the diamine were polymerized in 1‐methyl‐2‐pyrrolidinone and γ‐butyrolactone co‐solvent at 180°C for 15 hours in the presence of isoquinoline as catalyst. On the other hand, polyamide DiCN‐PA was synthesized according to the direct phosphorylation polycondensation technique described by Yamazaki from diamine and trans‐1,4‐cyclohexanedicarboxylic acid using triphenyl phosphite and pyridine as condensing agents. Results and Discussion Both polymers were soluble in several polar aprotic solvents and exhibited useful levels of thermal stability. The polymers were emissive with PL emission bands around 555 (bluish‐green) and 498 (cyan) nm in dilute 1‐methyl‐2‐pyrrolidinone solutions for polyimide and polyamide, respectively. In the solid film state, the polymers emit light green and yellow colors, which simulate the PL behavior of their aggregated states, thereby demonstrating aggregation‐induced fluorescence changes. Conclusions These results indicate that the incorporation of bulky dicyanoarylamine moiety and alicyclic monomer units into the rigid polymer backbones effectively disrupted the planarity of the chain packing which resulted to the fluorescent high‐performance polymers with desired properties for potential optoelectronic applications.

Study on Fluorescent Switching of Naphthopyran and Pyrene-Containing Dyad and Copolymer in Solutions and Films

Polymer-Derived Carbon Nanofiber and Its Photocurrent-Switching Responses of Carbon Nanofiber/Cu Nanocomposite in Wide Ranges of Excited Light Wavelength

Organic Polymorphs with Fluorescence Switching: Direct Evidence for Mechanical and Thermal Modulation of Excited State Transitions.

Multiple Stimuli-Responsive Fluorescence Behavior of Novel Polyamic Acid Bearing Oligoaniline, Triphenylamine, and Fluorene Groups.

Pyrene-Functionalized Polyacetylenes: Synthesis and Photoluminescence Property

Optical Switching and Fluorescence Modulation Properties of Photochromic Dithienylethene Derivatives

Azobenzene Functionalized Poly(diphenylacetylene): Polymer Synthesis and Tunable Fluorescent Emission

Fluorescence switching of triarylamine-based polyamides with pendant pyrene units and its application in electrochromic smart displays

Switchable 2,3-Dithienylmaleimide Bonded to Different Fluorophores: Synthesis and Photochromic Properties

Fluorescent Switch Based on Dithienylethene with Dansulfonamide in Multimedium

Electrochromic Polymer Achieving Synchronous Electrofluorochromic Switching for Optoelectronic Application

Fluorophore-photochrome co-embedded polymer nanoparticles for photoswitchable fluorescence bioimaging

From blue fluorescence to red fluorescence: Solid-state oxidative coupling polymerization of fluorene and anthracene or naphthalene

Solid-State Fluorescence Switching Using Photochromic Diarylethenes

Unconventional Photoswitching Behavior of a Diarylethene‐Perylenediimide Dyad in Nanoparticles Emerging from Multiple Intermolecular Energy Transfer Processes

A Photochromic Prototype Based on Difurylperhydrocyclopentene with Remarkable Photoswitching Behavior and in Vivo Application

Synthesis, characterization, and photophysical properties of dicyanoarylamine‐based semi‐aromatic polymers

Light and Heat-Driven Flexible Solid Supramolecular Polymer Displaying Phosphorescence and Reversible Photochromism

A New Biphotochromic Fluorescent Switch Based on Dithienylethene and Triphenylethylene: Synthesis, Crystal Structure, and Optical Waveguide

Positive and Negative Fluorescent Imaging Induced by Naphthalimide Polymers

Multi-stimuli-responsive fluorescence switching from a novel organic polymorphic benzoimido-benzamide derivative