Abstract:Vibration shaker testing is a great tool of validating the vibration fatigue performance of automotive components & systems. However, the representative vibration schedule requires a pre-knowledge of the acceleration history for the test object, which usually is not available until the later development phase of a vehicle program when physical properties are available. Sometimes, a generic vibration schedule developed from the worst-case loading profiles are used with risk of lacking correlation with later full vehicle durability test such as Road Test Simulator (RTS) or Proving Ground (PG) road test due to the higher loading amplitude. This paper proposes a virtual accelerometer approach to collect acceleration responses of a component from a virtual vehicle model. First, a multiple body dynamic model will be produced for virtual load calculation over a series of digitalized virtual proving ground road profiles. These loads will be then applied on the virtual vehicle CAE model with all representative components & subsystems. Acceleration response for the system of interest is then extracted from modal transient dynamic analysis. Later, the acceleration history is converted to frequency domain, and the associated spectral damage calculation is conducted. The final vibration profile is developed based on the equivalent damage concept. The virtual acceleration acquisition and physical acceleration acquisition show good agreement in both time domain and frequency domain. The profile generated from virtual acceleration acquisition covers very well for the physical acceleration acquisition. Overall, virtual acceleration-based profile ensures the conservative shake test results for the example studied. Compared to the physical accelerometer, the virtual accelerometer can provide acceleration data economically and quickly in the early phase of the product development. The proposed approach will ensure the component shaker test is conducted using the meaningful and representative vibration load.

A Method of Extracting Acceleration of Boost Phase Based on Orthogonal Curve Fitting

Research on a New S-curve Acceleration and Deceleration Control Method

A Phase Calibration Method for Single Channel Monopulse Tracking Systems Based on Curve Fitting Technique

An $\Omega$-Free Accelerometer Array Method for 2-D Trajectory Reconstruction

A ballistic heading estimation method based on single station only angle measurement

Trajectory Optimization for Launch Vehicle Boost Phase Based on Gauss Pseudospectral Method

Virtual Accelerometer Approach to Create Vibration Profile for Automotive Component Shake Test

A Fast Generation Method of Optimal Trajectory of Boost Phase for Boost-glide Vehicle

Research on Flexible Acceleration and Deceleration Method of NC System

Improved Algorithm for Phase-to-height Mapping in Phase Measuring Profilometry.

Research on kinetic kill vehicle's guidance method in boost phase

A measurement method of in-bore projectile motion acceleration based on bottom pressure correction

Servo System Identification Based on Curve Fitting to Phase-Plane Trajectory

An Actual Angle of Arrival Fitting Method for Correcting Errors Induced by Speed Fluctuation in Blade Tip Timing System

Efficient method for firing data calculation of boost-glide missile in mobile condition

A Method of Improving Performance of Measurement Accuracy for GNSS Receiver under Dynamic Scenarios

A rapid outliers detection and correction method for external ballistic velocity measurement data

Study on dynamic characteristics of acceleration process of spherical hybrid sliding bearings rotor system

A Stepped-Segmentation Method for the High-Speed Theoretical Elevator Car Air Pressure Curve Adjustment

Consecutive Tracking for Ballistic Missile Based on Bearings-Only During Boost Phase

Improved Non-contact Vibration Measurement Via Acceleration-based Blade Tip Timing