Abstract:Recent earthquakes in several developing countries have shown that reinforced concrete (RC) buildings with improper structural detailing experience severe damage under seismic motions. Using low-quality construction materials such as brick aggregates, resulting in low-strength concrete, significantly impacts the bond between rebar and concrete. Accurate evaluation of the bond performance of such low-strength concrete is one of the key issues for seismic safety assessment of RC buildings, especially in Bangladesh; thus, the bond performance is usually evaluated through laboratory tests. However, conventional measurements of bond stress based on rebar strains measured by electrical resistance strain gauges are likely to negatively impact the bond behavior/performance because of the reduced total contact area between rebar and concrete as well as the changing rebar surface boundary conditions. Under the above social and academic backgrounds, in this study, a new measurement technique that applies fiber Bragg grating (FBG) sensors embedded in optical fiber to rebar strain measurements is developed, and its effectiveness is investigated to realize more accurate measurements of the bond stress between rebar and concrete. Two 70% scaled RC beam-column joint specimens in which the beam rebar was anchored in a straight manner were constructed with identical detailing, except for the beam rebar strain measuring methods. The specimens were then subjected to cyclic lateral loading until failure. By comparing the experimental data acquired by the above two different devices (the FBG sensors and conventional strain gauges), it was found that the experimental bond strength on the beam rebar based on the strain data measured by the FBG sensors was much higher than that from the data measured using conventional strain gauges. Which negatively impacted the test data on the beam-column joint's capacity in the specimen applied the conventional measuring method, indicating the necessity of the presented method not only for accurate evaluation of the bond stress between rebar and concrete but also for seismic safety assessments of RC buildings.

Experimental Study on Measuring the Steel Stress via FBG Sensors

Study of Bond Behavior between Concrete and Steel Bars Based on New Beam Specimens

Experimental Investigation on Influence of Embedment Length, Bar Diameter and Concrete Cover on Bond Between Reinforced Bars and Steel Fiber Reinforced Concrete (SFRC)

Analytical Model for the Bond Stress-Slip Relationship of Deformed Bars in Normal Strength Concrete

Test study on the bond stress-slip relationship between concrete and steel bars

Bond Strength Evaluation of Corroded Steel Bars Via the Surface Crack Width Induced by Reinforcement Corrosion

Test Study on Bond Stress-Slip Relationship of Concrete and Steel Bar

Monitoring Epoxy Coated Steel under Combined Mechanical Loads and Corrosion Using Fiber Bragg Grating Sensors

Bond Behaviour of Normal/Recycled Concrete and Corroded Steel Bars

Study on the bond stress-slip relationship variation with the position

A Monitoring Method Based On Fbg For Concrete Corrosion Cracking

Probabilistic Analysis of Stress Concentration Factor of an Orthotropic Steel Bridge with FBG-Based Structural Health Monitoring System *

Test study on bond behavior of corroded steel bars and concrete

Experimental Research on Corrosion-Induced Cracking Monitoring Based on Optical Fiber Sensor

An Optical Fiber Sensor Method for Simultaneously Monitoring Corrosion and Structural Strain Induced by Loading

Strain Conditions Monitoring on Corroded Prestressed Steel Strands in Beams Based on Fiber Bragg Grating Sensors

Investigation of Bond Behavior between Steel Bar and Concrete under Coupled Effect of Fatigue Loading and Corrosion

Accurate measurement of the bond stress between rebar and concrete in reinforced concrete using FBG sensing technology

Real-time strain monitoring and control of urban bridge cluster monitoring system with FBG sensor

The Bond Behavior Between Concrete and Corroded Steel Bar under Repeated Loading

Statistical Analysis of Stress Signals from Bridge Monitoring by FBG System