Abstract:Even today, DC motors are still used in variety of applications, including home appliances, transportation, as well as industrial crane and rolling machine. However, achieving precise speed and torque control in DC drives at industry level could be challenging, as instability and reduced efficiency remains at large. This project focuses on developing a cascaded control system for a Separately Excited Brushed DC motor using dSPACE platform. The cascaded control system, designed using MATLAB Simulink, incorporates a proportional-integral (PI) controller at the speed loop and a Hysteresis controller at the current loop to improve robustness and dynamic performance. The experimental setup utilizes the dSPACE 1104 platform, an asymmetric bridge converter board, gate driver, and electrical load. Speed measurement is done using an incremental encoder, while current is measured using the ACS712 current sensor. The drive system was tested in alternate low and high speed cycle on various load level to test for stability, robustness and dynamic performance. The proposed control system was compared with PI-closed-loop control and open-loop control determine the best drive performance. Experimental results showed significant improvement in term of transient response and ripple reduction of speed and current for proposed cascaded current control over the closed-loop design.

Rapid Design of DC Motor Speed Control System Based on MATLAB

Low Cost Control Method for Brushless DC Motors Based on Fuzzy Logic Controller

Design of Speed Control System Based on Fuzzy-PID Hybrid Control for DC Motor

The Simulation Analysis of Fuzzy Control System of BLDCM

Feedback linearization control research of speed sensorless permanent magnet synchronous motor

A Rapid Development Method on Brushless DC motor Controller

DC Motor Speed Control Based on System Identification and PID Auto Tuning

Design of DC motor controller based on MBD

Control System for Brushless DC Motor Based on dSPACE

Fast Development of Flexible Motor Control System with Model Based Design

Rapid control prototype design of the DC/DC converter for Fuel Cell Electric Vehicles

Development of a DC Motor Speed Control System Based on PID

DSP-Based Speed Control of Brushless DC Motor

Design of speed regulation system of reversible DC motor

Design and Implementation of FOC Control Algorithm for PMSM Motor Based on Matlab/Simulink

Novel rapid control prototyping for permanent magnet synchronous motor via model-based design and STM32 chip

Design and Application of PLC-based Speed Control for DC Motor Using PID with Identification System and MATLAB Tuner

Design and Development of Cascaded Current Control in DC Motor Variable Speed Drive using dSPACE

Simulation Study of Brushless DC Motor Speed Control System Based on GA-PID

The Control System Design of BLDC Motor

Design of Double Closed Loop Control System for DC Motor Based on TX8C1010 Single Chip