Abstract:Rolling bodies in cageless ball bearings without cage control will always hit each other. This causes the rolling bodies to wear out faster and decreases the bearing's performance. But most of the available references only look at how well the bearing works when the cage is in place. They do not look at how the inner ring's dynamic response changes when the cage is removed and the rolling elements' motion changes. On the basis of this, a nonlinear rolling-body dynamics model with six degrees of freedom and contact between rolling bodies is suggested. The dynamics model of an automatic discrete system is built on the motion coupling and functional slot discrete theories. The power hardware re-turn method is used to figure out how to solve the dynamics model. The results show that after the rotor falls into the inner ring, the rolling bodies will cause cumulative collision for a short time. Then, because of the function slot, the occasional collision between the rolling bodies would not cause cumulative collision again, and the inner ring motion will be more stable. When the speed of the rotor's fall goes up, the rolling bodies hit each other more often. This makes the inner ring move more steadily, but there is a limit. To make sure that the theoretical analysis and the results of the theoretical solution are right, a high-speed camera was used. To make sure that the theoretical analysis and the results of the theoretical solution are right, we built a bearing test platform to take pictures of the rolling body of the bearing as it moved. The image processing program is used to figure out the rolling body's angular speed, compare the test results to the theoretical study and make sure that the theoretical study is right. The theoretical study is compared to the test results to see if the theoretical study is right.

Research on Power Flow Transmitted Through Rolling Bearing in the Gear Shaft-Plate Coupled Structure

Research on the modal building and experiment of the additional force of gear coupling

Study on Power Flow Characteristics of the System with Rotating Substructure

Power flow analysis of underwater vehicle propulsion shafting-shell coupled system based on analytical method

Research on internal flow field analysis and power loss modeling of the expansion seal ring

Simulation and Experimental Analysis of Rolling Element Bearing Fault in Rotor-Bearing-casing System

Layering Vibration Transfer Path Analysis of a Flexible Supported Gear System Based on the Vibration Power Flow Theory

Study on Structural Vibration Characteristics of L-Shaped Flexible Ring Gear and Establishment of System Coupling Vibration Model

Analysis of Vibration Characteristics of Face Gear powering-split Transmission System

Study on the dynamic characteristics of planetary gear transmission mechanism of metal cold rolling mill

Dynamic modeling and analysis for a drive axle gear transmission system

Dynamic modeling and analysis of load sharing characteristics of wind turbine gearbox

Vibration characterization of rolling bearings with compound fault features under multiple interference factors

Research on dynamic load sharing characteristics of double input face gear split-parallel transmission system

Investigation of the Vibration Features and Dynamic Load Sharing Characteristics of Concentric Face Gear Torque Split Transmission

Nonlinear Vibration Analysis of the Coupled Gear-Rotor-Bearing Transmission System for a New Energy Vehicle

Dynamic modelling and vibration characteristics of a marine compound gear transmission system

Dynamic Characteristics and Load Sharing of Herringbone Wind Power Gearbox

Analytical investigation on load-sharing characteristics for multi-power face gear split flow system

Research on multi-body dynamic model of automatic discrete system for protection bearing without cage

A new approach for analyzing internal load and fatigue life of deep groove ball bearing in high-speed gearbox system