Abstract:Storage-class memory (SCM) combines the benefits of a solid-state memory, such as high-performance and robustness, with the archival capabilities and low cost of conventional hard-disk magnetic storage. Among candidate solid-state nonvolatile memory technologies that could potentially be used to construct SCM, flash memory is a well-established technology and have been widely used in commercially available SCM incarnations. Flash-based SCM enables much better tradeoffs between performance, space and power than disk-based systems. However, write endurance is a significant challenge for a flash-based SCM (each act of writing a bit may slightly damage a cell, so one flash cell can be written 10^4--10^5 times, depending on the flash technology, before it becomes unusable). This is a well-documented problem and has received a lot of attention by manufactures that are using some combination of write reduction and wear-leveling techniques for achieving longer lifetime. In an effort to improve flash lifetime, first, by quantifying data longevity in an SCM, we show that a majority of the data stored in a solid-state SCM do not require long retention times provided by flash memory (i.e., up to 10 years in modern devices); second, by exploiting retention time relaxation, we propose a novel mechanism, called Dense-SLC (D-SLC), which enables us perform multiple writes into a cell during each erase cycle for lifetime extension; and finally, we discuss the required changes in the flash management software (FTL) in order to use this characteristic for extending the lifetime of the solid-state part of an SCM. Using an extensive simulation-based analysis of a flash-based SCM, we demonstrate that D-SLC is able to significantly improve device lifetime (between 5.1X and 8.6X) with no performance overhead and also very small changes at the FTL software.

Research and Implementation of SSD Lifespan Protection Mechanism

Measurement and Analysis of SSD Reliability Data Based on Accelerated Endurance Test

PLC-cache: Endurable SSD Cache for Deduplication-Based Primary Storage

Lifespan Analysis for Redundant Array of Independent Module Based Solid State Drives

Exploiting Data Longevity for Enhancing the Lifetime of Flash-based Storage Class Memory

Architectural Exploration to Address the Reliability Challenges for ReRAM-Based Buffer in SSD

Data Pattern Aware Reliability Enhancement Scheme for 3D Solid-State Drives

Lifespan-based garbage collection to improve SSD's reliability and performance

Improving Productivity and Efficiency of SSD Manufacturing Self-Test Process by Learning-Based Proactive Defect Prediction

Exploit Both SMART Attributes and NAND Flash Wear Characteristics to Effectively Forecast SSD-based Storage Failures in Clusters.

Error Characterization, Mitigation, and Recovery in Flash Memory Based Solid-State Drives

An Effective Dynamic Wear Leveling In The Application Of Solid State Drives

LDPC-in-SSD: making advanced error correction codes work effectively in solid state drives.

Balancing Page Endurance Variation Between Layers to Extend 3D NAND Flash Memory Lifetime

Predicting solid state drive reliability

Error Source and Latency-Aware Read Performance Optimization Scheme for Aged SSDs.

SREA: A Self-Recovery Effect Aware Wear-Leveling Strategy for the Reliability Extension of NAND Flash Memory

A New Multi-Tiered Solid State Disk Using Slc/Mlc Combined Flash Memory

A Latency-Aware Garbage Collection Strategy

Pattern-based Write Scheduling and Read Balance-oriented Wear-Leveling for Solid State Drivers

MScache: A buffer management scheme based on page-level address mapping for NAND-flash SSD